Search results
Results From The WOW.Com Content Network
In telecommunications, data transfer rate is the average number of bits , characters or symbols , or data blocks per unit time passing through a communication link in a data-transmission system. Common data rate units are multiples of bits per second (bit/s) and bytes per second (B/s). For example, the data rates of modern residential high ...
The figures below are simplex data rates, which may conflict with the duplex rates vendors sometimes use in promotional materials. Where two values are listed, the first value is the downstream rate and the second value is the upstream rate. The use of decimal prefixes is standard in data communications.
The physical layer net bitrate, [12] information rate, [6] useful bit rate, [13] payload rate, [14] net data transfer rate, [9] coded transmission rate, [7] effective data rate [7] or wire speed (informal language) of a digital communication channel is the capacity excluding the physical layer protocol overhead, for example time division ...
A data transmission speed 301 terabits per second was achieved by researchers at Aston University in the UK (Getty Images/iStockphoto) For comparison, the average broadband speed in the UK is 69.4 ...
Data communication, including data transmission and data reception, is the transfer of data, transmitted and received over a point-to-point or point-to-multipoint communication channel. Examples of such channels are copper wires , optical fibers , wireless communication using radio spectrum , storage media and computer buses .
Transmission rates are defined by rate of the bitstream of the digital signal and are designated by hyphenation of the acronym OC and an integer value of the multiple of the basic unit of rate, e.g., OC-48. The base unit is 51.84 Mbit/s. [2] Thus, the speed of optical-carrier-classified lines labeled as OC-n is n × 51.84 Mbit/s.
The packet transmission time in seconds can be obtained from the packet size in bit and the bit rate in bit/s as: Packet transmission time = Packet size / Bit rate. Example: Assuming 100 Mbit/s Ethernet, and the maximum packet size of 1526 bytes, results in Maximum packet transmission time = 1526×8 bit / (100 × 10 6 bit/s) ≈ 122 μs
The bus bandwidth therefore only has an effect on the number of channels that can be sent at a time, not the speed or latency of the transmission. Low speed (LS) rate of 1.5 Mbit/s is defined by USB 1.0. It is very similar to full-bandwidth operation except each bit takes 8 times as long to transmit.