Search results
Results From The WOW.Com Content Network
The control grid is an electrode used in amplifying thermionic valves (vacuum tubes) such as the triode, tetrode and pentode, used to control the flow of electrons from the cathode to the anode (plate) electrode. The control grid usually consists of a cylindrical screen or helix of fine wire surrounding the cathode, and is surrounded in turn by ...
1 – Tetrode with a space charge grid (the 2nd grid is the control grid) 2 – Tetrode with a screen grid (the 1st grid is the control grid) 3 – Power pentode; 4 – Binode, a diode/triode or diode/tetrode; 5 – Remote-cutoff RF tetrode; 6 – Signal pentode; 7 – Remote-cutoff RF pentode; 8 – Sharp-cutoff hexode frequency changer; 9 ...
The mutual conductance tester tests the tube dynamically by applying bias and an AC voltage to the control grid, and measuring the current obtained on the plate, while maintaining the correct DC voltages on the plate and screen grid. This setup measures the transconductance of the tube, indicated in micromhos. [3]
The control grid and cathode are operated as a diode while at the same time the control grid voltage exerts its usual influence on the electron stream from cathode to plate. In the circuit, a capacitor (the grid condenser ) couples a radio frequency signal (the carrier) to the control grid of an electron tube. [ 16 ]
The control grid of the variable-mu pentode is constructed so as to result in a given incremental change of control grid voltage having less effect on change of anode current as the control grid voltage increases negatively relative to the cathode. [7] The control grid often has the form of a helix of varying pitch. [8]
Plate detector circuit with cathode bias. Cathode bias RC time constant three times period of lowest carrier frequency. C L is typically around 250 pF.. In electronics, a plate detector (anode bend detector, grid bias detector) is a vacuum tube circuit in which an amplifying tube having a control grid is operated in a non-linear region of its grid voltage versus plate current transfer ...
Between the screen grid and the cathode is the control grid. The beam confining plates have been removed. The getter pan, getter pan supports and the upper mica disc have been removed. The elliptical helix of the screen grid surrounds the control grid. The screen grid support rods are on the left and right outside of the control grid support rods.
Pin 4 – Grid 2 (Screen) Pin 5 – Grid 1 (control) Pin 6 – n.c Pin 7 – Heater . Pin 8 – Cathode & beam-forming plates: Typical class-A amplifier operation; Anode voltage: 350 V: Anode current: 54 mA: Screen voltage: 250 V: Bias voltage: −18 V: Anode resistance: 5 kOhms: Typical class-AB amplifier operation (Values are for two tubes ...