Ads
related to: how to connect antenna samsung tv
Search results
Results From The WOW.Com Content Network
Canada had a similar analog TV termination date set to September 1, 2011 (except in some remote northern regions). [citation needed] It was feared that the US switch-off would cause millions of non-cable- and non-satellite-connected TV sets to "go dark". Viewers who did not upgrade, either to a television with a digital tuner or a set-top box ...
Belling-Lee connectors Flex Type F connectors. A TV aerial plug is a connector used to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal amplifiers, CATV distribution equipment, TV sets and FM / DAB-radio receivers.
A digital TV converter box. A digital television adapter (DTA), commonly known as a converter box, DTV converter , or decoder box, is a television tuner that receives a digital television (DTV) transmission, and converts the digital signal into an analog signal that can be received and displayed on an analog television set.
OTA antennas are digital receivers that pick up signals broadcast by local TV towers, allowing you to watch local programming without cable. These antennas cost anywhere from $15 to $50.
The F connector (also F-type connector) is a coaxial RF connector commonly used for "over the air" terrestrial television, cable television and universally for satellite television and cable modems, usually with RG-6/U cable or with RG-59/U cable.
A typical modern set-top box, along with its remote control - pictured here a digital terrestrial TV receiver by TEAC. A set-top box (STB), also known as a cable box, receiver, or simply box, and historically television decoder or a converter, [1] is an information appliance device that generally contains a TV tuner input and displays output to a television set, turning the source signal into ...
A short antenna pole next to a house Multiple Yagi TV aerials. Antennas are commonly placed on rooftops and sometimes in attics. Placing an antenna indoors significantly attenuates the level of the available signal. [19] [20] Directional antennas must be pointed at the transmitter they are receiving; in most cases great accuracy is not needed ...
The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.