Ads
related to: kawasaki mule 4010 rear axle replacement
Search results
Results From The WOW.Com Content Network
The Kawasaki MULE (Multi-Use Light Equipment) is a series of lightweight Utility Task Vehicle that have been built by Kawasaki since 1988. Initially available with a 454 cc (27.70 cu in) twin-cylinder engine in the original MULE 1000 model, the range has grown and been gradually updated over the years, and now includes both petrol and diesel variants.
In a rear-wheel drive vehicle this axle is capable of angular movement about the kingpin for steering the vehicle. The stub or stud axle is named so because it resembles the shape of a stub or stud, like a truncated end of an axle, short in shape and blunt. There are four general designs: [1] Elliot axle; Reversed Elliot axle; Lemoine axle
In rear-wheel drive cars and trucks, the engine turns a driveshaft (also called a propeller shaft or tailshaft) which transmits the rotational force to a drive axle at the rear of the vehicle. The drive axle may be a live axle, but modern rear-wheel drive automobiles generally use a split axle with a differential. In this case, one half-axle or ...
The Dana/Spicer Model 60 is an automotive axle manufactured by Dana Holding Corporation and used in OEM pickup and limited passenger car applications by Chevrolet, Dodge, Chrysler, Jeep, Ford and Land Rover. There are front and rear versions of the Dana 60.
There are discernible differences between the GM and Ram versions, evident in the gaskets used and the axle cover designs. The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles.
The mechanism was invented in 1927 by Tullio Campagnolo, an Italian bicycle racer. He was frustrated when he attempted to change gears during a race. At the time there was but one cog on each side of the rear hub, so gear changes necessitated stopping, removing the rear wheel, flipping it over horizontally so that the opposite cog is engaged by the chain, and finally reinstalling the wheel.