Ads
related to: parker hose size chart medline
Search results
Results From The WOW.Com Content Network
A 37° flare type end fitting for flexible hose The AN thread (also A-N ) is a particular type of fitting used to connect flexible hoses and rigid metal tubing that carry fluid. It is a US military-derived specification that dates back to World War II and stems from a joint standard agreed upon by the Army Air Corps and Navy, hence AN.
One side is connected to a flexible supply hose; the other may be attached to a manifold, valve, tool, or another hose. A female coupler is used on the supply side, and a male nipple is used on the receiving side. Fitting profiles have identifiable geometry on the male end, but care must be taken to use a compatible coupler.
Cam and groove fittings are commonly available in several materials, including stainless steel, aluminum, brass, and polypropylene. [2] Because there are no threads to become fouled, cam and groove couplings are popular in moderately dirty environments, such as septic tank pump trucks and chemical or fuel tanker trucks.
Medline Industries, LP is an American private healthcare company headquartered in Northfield, Illinois. In June 2021 it was acquired by a consortium of private equity firms Blackstone , Carlyle and Hellman & Friedman valuing the company at $34 billion in one of the largest leveraged buyouts of all time.
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
5-inch (13 cm) flex suction hose with Storz fittings, mounted on an engine. Flexible suction hose (Flex suction or suction hose), not to be confused with hard suction hose in U.S., is a specific type of fire hose used in drafting operations, when a fire engine uses a vacuum to draw water from a portable water tank, pool, or other static water source.
The clamp is placed over the end of the hose or tube to be connected and when each ear is closed at the base of the ear with a special pincer tool, it permanently deforms, pulling the band, and causing the band to tighten around the hose. The size of clamp should be chosen such that the ear(s) are almost completely closed on installation.
Hose barb fittings are small curved, bent or T-shaped pipes, hoses or tubes with hose barbs on at least one side used to join two or more pieces of piping (hosing, tubing) together. [1] Hose barbs are commonly used in the agriculture industry to connect anhydrous ammonia (NH 3 ) hoses.