Search results
Results From The WOW.Com Content Network
Grease fitting on a bearing A grease nipple on the driver's door of a 1956 VW Beetle. A grease fitting, grease nipple, Zerk fitting, grease zerk, Alemite fitting, or divit is a metal fitting used in mechanical systems to feed lubricants, usually lubricating grease, into a bearing under moderate to high pressure using a grease gun.
They are used underwater, in drilling operations, in outer space, and for pneumatic-power, plumbing, heating, electrical, and fire-suppression applications. Quick connect fittings are intended to be applied more easily than traditional fittings, requiring only that the pipes be pushed together firmly to lock the teeth of the fitting firmly.
A grease gun (pneumatic) A grease gun is a common workshop and garage tool used for lubrication. The purpose of the grease gun is to apply lubricant through an aperture to a specific point, usually from a grease cartridge to a grease fitting or 'nipple'. The channels behind the grease nipple lead to where the lubrication is needed.
On a standard-gauge railway, the nominal mounting height for the coupler (rail top to coupler center) is 33 inches (838 mm), with a 34 + 1 ⁄ 2 ± 1 inch (876 ± 25 mm) maximum height on empty cars and 31 + 1 ⁄ 2 ± 1 inch (800 ± 25 mm) minimum height on loaded cars.
The most common causes are accidents with grease guns, paint sprayers, and pressure washers, but working on diesel and gasoline engine fuel injection systems as well as pinhole leaks in pressurized hydraulic lines can also cause this injury. Additionally, there is at least one known case of deliberate self-injection with a grease gun. [2]
For parts that are inaccessible for lubrication after assembly, a dry film lubricant can be sprayed. After the solvent evaporates, the coating cures at room temperature to form a solid lubricant. Pastes are grease-like lubricants containing a high percentage of solid lubricants used for assembly and lubrication of highly loaded, slow-moving parts.
The diagram from Beard's 1897 coupler patent [1]. Janney couplers were first patented in 1873 by Eli H. Janney (U.S. patent 138,405). [2] [3] Andrew Jackson Beard was amongst various inventors that made a multitude of improvements to the knuckle coupler; [1] Beard's patents were U.S. patent 594,059 granted 23 November 1897, which then sold for approximately $50,000, and U.S. patent 624,901 ...
Engineering fits are generally used as part of geometric dimensioning and tolerancing when a part or assembly is designed. In engineering terms, the "fit" is the clearance between two mating parts, and the size of this clearance determines whether the parts can, at one end of the spectrum, move or rotate independently from each other or, at the other end, are temporarily or permanently joined.