When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Punch down tool - Wikipedia

   en.wikipedia.org/wiki/Punch_down_tool

   A punch down tool, punchdown tool, IDC tool, or a Krone tool (named after the Krone LSA-PLUS connector), is a small hand tool used by telecommunication and network technicians. It is used for inserting wire into insulation-displacement connectors on punch down blocks , patch panels , keystone modules , and surface mount boxes (also known as ...

3. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The included angle of the spotting drill bit should be the same as, or greater than, the conventional drill bit so that the drill bit will then ...

4. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A punch is a tool used to indent or create a hole through a hard surface. They usually consist of a hard metal rod with a narrow tip at one end and a broad flat "butt" at the other. When used, the narrower end is pointed against a target surface and the broad end is struck with a hammer or mallet , causing the blunt force of the blow to be ...

5. 17+ best Home Depot Labor Day deals - AOL

   www.aol.com/news/17-best-home-depot-labor...

   LG 4.5 cu. Stackable Front Load Washer $648.00 at Home Depot. LG 4.5 cu. Stackable Front Load Washer $648.00 at Lowe's. LG 4.5 cu. Stackable Front Load Washer $649.99 at Best Buy. The stackable ...

6. Cost estimate - Wikipedia

   en.wikipedia.org/wiki/Cost_estimate

   A cost estimate is the approximation of the cost of a program, project, or operation. The cost estimate is the product of the cost estimating process. The cost estimate has a single total value and may have identifiable component values. A problem with a cost overrun can be avoided with a credible, reliable, and accurate cost estimate. A cost ...

7. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   Punching is a forming process that uses a punch press to force a tool, called a punch, through the workpiece to create a hole via shearing. Punching is applicable to a wide variety of materials that come in sheet form, including sheet metal , paper , vulcanized fibre and some forms of plastic sheet.