Search results
Results From The WOW.Com Content Network
Measurements of a typical Tune-o-matic bridge Schaller Wide Travel Tune-o-Matic a.k.a. Harmonica bridge on The Fool. Since its invention, different versions by Gibson have been used: • ABR-1 without retainer wire: 1954–1962 • ABR-1 with retainer wire: 1962–1975 • Schaller Wide travel Tune-o-Matic a.k.a. "Harmonica bridge": 1970-1980 (Kalamazoo plant) • Modern TOM a.k.a. "Nashville ...
The System I bridge string height is set by adjustable pivot post screws and has no individual string height adjustments but has individual string intonation adjustments and is very much like the Gibson Tune-o-matic bridge in terms of intonation and string height adjustments. The System I tremolo system uses a behind the nut string locking ...
This is an important adjustment especially when changing the gauge of the string set on the guitar. There are practical limits to this technique: too high and it could bend the posts and the strings will not seat properly into the bridge saddles; too low and the string break will rest on the rear of the bridge, killing sustain and tone.
Truss rod adjustment at the heel of the neck. 2 vintage style string trees. 21 medium frets. "F" tuners (West German-manufactured), and "F" 4 bolt neck plate w/plastic pad. 3 Ply BWB through 1981 and WBW through 1982 pickguard with foil backing. White plastic nut. 25.5 in (65 cm) scale length. Bridge uses a string spacing of 0.404 in (10.26 mm).
On a cello, the strings are attached to the tailpiece and are held above the soundboard by the bridge.. A bridge is a device that supports the strings on a stringed musical instrument and transmits the vibration of those strings to another structural component of the instrument—typically a soundboard, such as the top of a guitar or violin—which transfers the sound to the surrounding air.
One end is pierced for the string; the other is squared off to fit in a tuning lever socket. The middle section, which would pass through the wood, is tapered. A variety of methods are used to tune different stringed instruments. Most change the pitch produced when the string is played by adjusting the tension of the strings.
Truss rods are frequently made out of steel, though graphite and other materials are sometimes used.. The truss rod can be adjusted to compensate for expansion or contraction in the neck wood due to changes in humidity or temperature, or to compensate for changes in the tension of the strings (the thicker the guitar string, the higher its tension when tuned to correct pitch) or using different ...
It featured a combination bridge and pickup assembly, which used the pickup from Fender's "Champion" lap steel guitar, with individual pole pieces for each string mounted at a slant, and three bridge saddles, which allowed adjustment of individual string height, but adjustment of intonation only in pairs.