Ads
related to: entrenched vs intrenched ends of roof construction diagram example easy
Search results
Results From The WOW.Com Content Network
Butterfly roof (V-roof, [8] London roof [9]): A V-shaped roof resembling an open book. A kink separates the roof into two parts running towards each other at an obtuse angle. Karahafu: A type of gable found in some traditional Japanese buildings. Hidden roof: A type of Japanese roof construction.
Domestic roof construction is the framing and roof covering which is found on most detached houses in cold and temperate climates. [1] Such roofs are built with mostly timber , take a number of different shapes , and are covered with a variety of materials .
INTERIOR VIEW SOUTH TOWARD MOVEABLE FIELD LEVEL SEATS. - Houston Astrodome, 8400 Kirby Drive, Houston, Harris County, TX HAER TX-108-9. The Lamella roof (also sometimes called the "Zollinger roof" for its inventor Friedrich Zollinger, a municipal building surveyor from Merseburg in the German state of Saxony-Anhalt [1]) is a construction type where the roof is supported by an arched network of ...
Double-tee roof structure of an indoor swimming pool. In non-residential buildings, the roof structure may be flat. Structural concrete is an alternative for flat roof construction. There are three main categories for such method: precast/prestressed, cast-in-place and shell. Within the precast/prestressed concrete roofing, the double tees are ...
A cruck or crook frame is a curved timber, one of a pair, which support the roof of a building, historically used in England and Wales. This type of timber framing consists of long, generally naturally curved, timber members that lean inwards and form the ridge of the roof. These posts are then generally secured by a horizontal beam which then ...
The hammerbeam roof of Westminster Hall in London, designed by Hugh Herland and installed between 1395 and 1399, was the largest timber-roofed space in medieval Europe, spanning a distance of just over 20 metres (66 ft). [14] It is considered to be the best example of a hammer-beam truss in England. [15]
The porch's roof treatment was the same as in the interior room, but the space provided was used for different purposes. Vigas were usually installed with the smaller ends to one side of the roof to facilitate good drainage. [12] Vigas usually sat directly on the adobe or stone walls and were strapped.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.