Search results
Results From The WOW.Com Content Network
Due to the higher density, diesel fuel offers a higher volumetric energy density: the density of EN 590 diesel fuel is defined as 0.820 to 0.845 kg/L (6.84 to 7.05 lb/US gal) at 15 °C (59 °F), about 9.0-13.9% more than EN 228 gasoline (petrol)'s 0.720–0.775 kg/L (6.01–6.47 lb/US gal) at 15 °C, which should be put into consideration when ...
Table of specific heat capacities at 25 °C (298 K) unless otherwise noted. [citation needed] Notable minima and maxima are shown in maroon. Substance Phase Isobaric mass heat capacity c P J⋅g −1 ⋅K −1 Molar heat capacity, C P,m and C V,m J⋅mol −1 ⋅K −1 Isobaric volumetric heat capacity C P,v J⋅cm −3 ⋅K −1 Isochoric ...
The lower heating value of natural gas is normally about 90% of its higher heating value. This table is in Standard cubic metres (1 atm, 15 °C), to convert to values per Normal cubic metre (1 atm, 0 °C), multiply above table by 1.0549.
The melting point (or, rarely, liquefaction point) of a substance is the temperature at which it changes state from solid to liquid. At the melting point the solid and liquid phase exist in equilibrium. The melting point of a substance depends on pressure and is usually specified at a standard pressure such as 1 atmosphere or 100 kPa.
Avoirdupois pound per cubic inch (1 g/cm 3 ≈ 0.036127292 lb/cu in) pound per cubic foot (1 g/cm 3 ≈ 62.427961 lb/cu ft) pound per cubic yard (1 g/cm 3 ≈ 1685.5549 lb/cu yd) pound per US liquid gallon (1 g/cm 3 ≈ 8.34540445 lb/US gal) pound per US bushel (1 g/cm 3 ≈ 77.6888513 lb/bu) slug per cubic foot
The gel point of petroleum products is the temperature at which the liquids gel so they no longer flow by gravity or can be pumped through fuel lines. This phenomenon happens when the petroleum product reaches a low enough temperature to precipitate interlinked paraffin wax crystals throughout the fluid .
"To get the same amount of 50 grams of protein that you get from steak," he says, "you would need to consume more than twice as many soybeans in terms of overall weight."
melting point of an alloy of one part lead, four parts tin and five parts bismuth 48: 3: melting point of an alloy of equal parts of bismuth and tin 57: 3 + 1 ⁄ 4: melting point of an alloy of one part bismuth and two parts tin 68: 3 + 1 ⁄ 2: melting point of an alloy of one part bismuth and eight parts tin 81: melting point of bismuth 96: ...