Search results
Results From The WOW.Com Content Network
A process can store data in memory-mapped files on memory-backed file systems, such as the tmpfs file system or file systems on a RAM drive, and map files into and out of the address space as needed. A set of processes may still depend upon the enhanced security features page-based isolation may bring to a multitasking environment.
In this case the page is paged out to a secondary store located on a medium such as a hard disk drive (this secondary store, or "backing store", is often called a swap partition if it is a disk partition, or a swap file, swapfile or page file if it is a file). When this happens the page needs to be taken from disk and put back into physical memory.
Memory segmentation is an operating system memory management technique of dividing a computer's primary memory into segments or sections.In a computer system using segmentation, a reference to a memory location includes a value that identifies a segment and an offset (memory location) within that segment.
A system with a smaller page size uses more pages, requiring a page table that occupies more space. For example, if a 2 32 virtual address space is mapped to 4 KiB (2 12 bytes) pages, the number of virtual pages is 2 20 = (2 32 / 2 12). However, if the page size is increased to 32 KiB (2 15 bytes), only 2 17 pages are required. A multi-level ...
The theoretically optimal page replacement algorithm (also known as OPT, clairvoyant replacement algorithm, or Bélády's optimal page replacement policy) [3] [4] [2] is an algorithm that works as follows: when a page needs to be swapped in, the operating system swaps out the page whose next use will occur farthest in the future. For example, a ...
Pagination, also known as paging, is the process of dividing a document into discrete pages, either electronic pages or printed pages.. In reference to books produced without a computer, pagination can mean the consecutive page numbering to indicate the proper order of the pages, which was rarely found in documents pre-dating 1500, and only became common practice c. 1550, when it replaced ...
A memory-mapped file is a segment of virtual memory [1] that has been assigned a direct byte-for-byte correlation with some portion of a file or file-like resource. This resource is typically a file that is physically present on disk, but can also be a device, shared memory object, or other resource that an operating system can reference through a file descriptor.
If the paging unit is enabled, addresses in a segment are now virtual addresses, rather than physical addresses as they were on the 80286. That is, the segment starting address, the offset, and the final 32-bit address the segmentation unit derived by adding the two are all virtual (or logical) addresses when the paging unit is enabled.