Search results
Results From The WOW.Com Content Network
The converse is pound per square inch gauge (psig), indicating that the pressure is relative to atmospheric pressure. For example, a bicycle tire pumped up to 65 psig in a local atmospheric pressure at sea level (14.7 psi) will have a pressure of 79.7 psia (14.7 psi + 65 psi).
10 kPa 1.5 psi Pressure increase per meter of a water column [26]: 10 kPa 1.5 psi Decrease in air pressure when going from Earth sea level to 1000 m elevation [citation needed]
A msw is defined as 0.1 bar (= 10,000 Pa), is not the same as a linear metre of depth. 33.066 fsw = 1 atm [citation needed] (1 atm = 101,325 Pa / 33.066 = 3,064.326 Pa). The pressure conversion from msw to fsw is different from the length conversion: 10 msw = 32.6336 fsw, while 10 m = 32.8083 ft. [citation needed]
[1] [2] By the barometric formula, 1 bar is roughly the atmospheric pressure on Earth at an altitude of 111 metres at 15 °C. The bar and the millibar were introduced by the Norwegian meteorologist Vilhelm Bjerknes, who was a founder of the modern practice of weather forecasting, with the bar defined as one mega dyne per square centimeter. [3]
One bar is 100 kPa or approximately ambient pressure at sea level. Ambient pressure may in other circumstances be measured in pounds per square inch (psi) or in standard atmospheres (atm). The ambient pressure at sea level is approximately one atmosphere, which is equal to 1.01325 bars (14.6959 psi), which is close enough for bar and atm to be ...
The last equation may be identified as the pressure coefficient, meaning that Newtonian theory predicts that the pressure coefficient in hypersonic flow is: = For very high speed flows, and vehicles with sharp surfaces, the Newtonian theory works very well.
Since 1982, STP is defined as a temperature of 273.15 K (0 °C, 32 °F) and an absolute pressure of 100 kPa (1 bar). Conversions between each volume flow metric are calculated using the following formulas: Prior to 1982,
In these equations, g 0, M and R * are each single-valued constants, while P, L, T, and h are multivalued constants in accordance with the table below. The values used for M , g 0 , and R * are in accordance with the U.S. Standard Atmosphere , 1976, and the value for R * in particular does not agree with standard values for this constant. [ 2 ]