Ads
related to: weight of steel pipe per foot chart for water pressure gauge
Search results
Results From The WOW.Com Content Network
Feet of water is an alternative way to specify pressure as height of a water column; it is conventionally equated to 2,989.067 pascals (0.4335275 psi). [ 3 ] In North America , air and other industrial gases are often measured in inches of water when at low pressure.
h f = head loss in meters (water) over the length of pipe; L = length of pipe in meters; Q = volumetric flow rate, m 3 /s (cubic meters per second) C = pipe roughness coefficient; d = inside pipe diameter, m (meters) Note: pressure drop can be computed from head loss as h f × the unit weight of water (e.g., 9810 N/m 3 at 4 deg C)
4.4 When pipe is cold expanded, the amount of expansion shall not exceed one and one-half percent (1-1⁄2%) of the specified outside diameter of the pipe. [4] APPLICATIONS ASTM A53 pipeline is planned for mechanical as well as pressure applications and is also appropriate for ordinary usages in vapor, water, gas and also air lines. [5]
The number system, like Sch 40, 80, 160, were set long ago and seem a little odd. For example, Sch 20 pipe is even thinner than Sch 40, but same OD. And while these pipes are based on old steel pipe sizes, there is other pipe, like cpvc for heated water, that uses pipe sizes, inside and out, based on old copper pipe size standards instead of steel.
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
Hydraulic head (or piezometric head) is a specific measurement of the potential of water above a vertical datum. [7] It is the height of the free surface of water above a given point beneath the surface. [4] Pumping level is the level of water in the well during pumping. [8] Specific capacity is the well yield per unit of drawdown. [8]
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
ASTM A500 is a standard specification published by the ASTM for cold-formed welded and seamless carbon steel structural tubing in round, square, and rectangular shapes. It is commonly specified in the US for hollow structural sections, but the more stringent CSA G40.21 is preferred in Canada.