Ads
related to: hydraulic suspension upgrade kit
Search results
Results From The WOW.Com Content Network
For many automobile owners, it was too expensive to have an auto shop install the hydraulics in their car for them. In the early 1960s, owners were left to do the mechanics for their own cars because the kits were not sold in stores until the later 1960s. These hydraulic kits were known as "trays" to many consumers.
Pressure flows from the hydraulic circuit to the suspension cylinders, pressurizing the bottom part of the spheres and suspension cylinders. Suspension works by means of a piston forcing LHM into the sphere, compressing the nitrogen in the upper part of the sphere; damping is provided by a two-way 'leaf valve' in the opening of the sphere.
The interconnection is made up of hydraulic piping and a control cylinder which is located at the frame rail. [2] KDSS, which is fully mechanical, can disengage the stabilizer bars (the bars are jointed, allowing movement independent of one another). [2] This system will not engage during normal driving conditions, when hydraulic pressure is equal.
An active suspension is a type of automotive suspension that uses an onboard control system to control the vertical movement of the vehicle's wheels and axles relative to the chassis or vehicle frame, rather than the conventional passive suspension that relies solely on large springs to maintain static support and dampen the vertical wheel movements caused by the road surface.
Land Rover developed a self-levelling rear suspension using the "Boge Hydromat" self-energising hydraulic strut. [13] Of similar construction to a hydraulic shock absorber the strut used the motion of the suspension travelling over bumps to pump itself back up to a pre-set height. It was sufficiently powerful to regain up to 85% of normal ride ...
The pivot bearings at each end of the lower link are widely spaced so as to provide maximum longitudinal rigidity. Suspension is provided by two coil spring and damper units (yellow) on each side of the differential casing (four in total), the spring and damper units attaching to the crossbeam at the top and the lower link at the bottom.