Search results
Results From The WOW.Com Content Network
The JK flip-flop, augments the behavior of the SR flip-flop (J: Set, K: Reset) by interpreting the J = K = 1 condition as a "flip" or toggle command. Specifically, the combination J = 1, K = 0 is a command to set the flip-flop; the combination J = 0, K = 1 is a command to reset the flip-flop; and the combination J = K = 1 is a command to toggle ...
dual J-K negative-edge-triggered flip-flop, clear 14 SN74H103: 74x104 1 J-K master-slave flip-flop 14 SN74104: 74x105 1 J-K master-slave flip-flop, J2 and K2 inverted 14 SN74105: 74x106 2 dual J-K negative-edge-triggered flip-flop, preset and clear 16 SN74H106: 74x107 2 dual J-K flip-flop, clear 14 SN74LS107A: 74x108 2
Flip-flop excitation tables [ edit ] In order to complete the excitation table of a flip-flop , one needs to draw the Q(t) and Q(t + 1) for all possible cases (e.g., 00, 01, 10, and 11), and then make the value of flip-flop such that on giving this value, one shall receive the input as Q(t + 1) as desired.
The 7400 series contains hundreds of devices that provide everything from basic logic gates, flip-flops, and counters, to special purpose bus transceivers and arithmetic logic units (ALU). Specific functions are described in a list of 7400 series integrated circuits. Some TTL logic parts were made with an extended military-specification ...
The JK flip-flop augments the behavior of the SR flip-flop (J=Set, K=Reset) by interpreting the J = K = 1 condition as a "flip" or toggle command. This is an important distinction as it would confuse me to see S = R = 1 in the introduction sentence and then to read the Characteristic table, which has J = K = 1 for the flip.
At each advance, the bit on the far left (i.e. "data in") is shifted into the first flip-flop's output. The bit on the far right (i.e. "data out") is shifted out and lost. The data is stored after each flip-flop on the "Q" output, so there are four storage "slots" available in this arrangement, hence it is a 4-bit register.
The pulse generator output is fed into the clock generator which is used to clock the D flip-flop. Based on the input and output signals, if there is a need to change the state of the D flip-flop, then the clock is allowed to switch to cause a transition; else, the clock is not allowed to transition.
The output of a flip-flop is constant until a pulse is applied to its "clock" input, upon which the input of the flip-flop is latched into its output. In a synchronous logic circuit, an electronic oscillator called the clock generates a string (sequence) of pulses, the "clock signal".