When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Residual-current device - Wikipedia

   en.wikipedia.org/wiki/Residual-current_device

   A residual-current device (RCD), residual-current circuit breaker (RCCB) or ground fault circuit interrupter (GFCI) [a] is an electrical safety device, more specifically a form of Earth-leakage protection device, that interrupts an electrical circuit when the current passing through a conductor is not equal and opposite in both directions, therefore indicating leakage current to ground or ...

3. Earth-leakage protection device - Wikipedia

   en.wikipedia.org/wiki/Earth-leakage_circuit_breaker

   Such devices may be found in the form of either a circuit breaker, known as an earth-leakage circuit breaker (ELCB), or built into a socket (aka receptacle). Voltage-operated ELCBs can still be found in the wild, though these largely fell out of favour after the invention of the current-sensing based RCD (aka GFCI) technology.

4. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   Ground-fault circuit interrupter (GFCI) protection is required on receptacles in wet locations and locations where there exists an easy path for fault current to travel to earth. This includes all receptacles intended to service kitchen counter surfaces, crawl spaces at or below grade level, basements, garages and accessory buildings, bathrooms ...

5. Ground and neutral - Wikipedia

   en.wikipedia.org/wiki/Ground_and_neutral

   Grounding is also an integral path for home wiring because it causes circuit breakers to trip more quickly (ie, GFCI), which is safer. Adding new grounds requires a qualified electrician with knowledge particular to a power distribution region. Neutral is a circuit conductor that normally completes the circuit back to the source.

6. Ground (electricity) - Wikipedia

   en.wikipedia.org/wiki/Ground_(electricity)

   This means that the system will not immediately trip on the first ground fault. If a second ground fault occurs, a ground fault protection relay must trip the breaker to protect the circuit. On an HRG system, a sensing resistor is used to continuously monitor system continuity.

7. Ground continuity monitor - Wikipedia

   en.wikipedia.org/wiki/Ground_continuity_monitor

   The automatic cord mounted GCMs eliminate the need to test each cord or circuit, since the electrical impedance to ground is measured at the attached cord device and visibility indicated there via an LED. These inspections are required by the OSHA regulation on “receptacles which are not a part of the permanent wiring of the building”. [3]