Ads
related to: hobby copper wire
Search results
Results From The WOW.Com Content Network
An example of a copper alloy conductor is cadmium copper wire, which is used for railroad electrification in North America. [5] In Britain the BPO (later Post Office Telecommunications ) used cadmium copper aerial lines with 1% cadmium for extra strength; for local lines 40 lb/mile (1.3 mm dia) and for toll lines 70 lb/mile (1.7 mm dia).
Jump wire material for ready-made or homemade wires should usually be 22 AWG (0.33 mm 2) solid copper, tin-plated wire - assuming no tiny plugs are to be attached to the wire ends. The wire ends should be stripped 3 ⁄ 16 to 5 ⁄ 16 in (4.8 to 7.9 mm). Shorter stripped wires might result in bad contact with the board's spring clips ...
A small reel of insulated copper wire [2] is mounted at the top of the tool. The wire runs down the center of the wiring pencil and through a hardened tip, which is small enough to move between the pins of 0.1" pitch DIL chip allowing connections to be wrapped and the wire to be led across the circuit board to the next point it's needed.
This page was last edited on 21 October 2016, at 18:35 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
Electroluminescent wire (often abbreviated as EL wire) is a thin copper wire coated in a phosphor that produces light through electroluminescence when an alternating current is applied to it. It can be used in a wide variety of applications—vehicle and structure decoration, safety and emergency lighting, toys, clothing etc.—much as rope ...
Wire drawing is a metalworking process used to reduce the cross-section of a wire by pulling the wire through one or more dies. There are many applications for wire drawing, including electrical wiring, cables, tension-loaded structural components, springs, paper clips, spokes for wheels, and stringed musical instruments.