Ad
related to: vapor liquid equilibrium pdf
Search results
Results From The WOW.Com Content Network
In thermodynamics and chemical engineering, the vapor–liquid equilibrium (VLE) describes the distribution of a chemical species between the vapor phase and a liquid phase. The concentration of a vapor in contact with its liquid, especially at equilibrium , is often expressed in terms of vapor pressure , which will be a partial pressure (a ...
The vapor-liquid equilibrium line (the curved line from (0,0) to (1,1) in Figure 1) represents the vapor phase composition for a given liquid phase composition at equilibrium. Vertical lines drawn from the horizontal axis up to the x = y line indicate the composition of the inlet feed stream, the composition of the top (distillate) product ...
DePriester Charts provide an efficient method to find the vapor-liquid equilibrium ratios for different substances at different conditions of pressure and temperature. The original chart was put forth by C.L. DePriester in an article in Chemical Engineering Progress in 1953.
The equilibrium conditions are shown as curves on a curved surface in 3D with areas for solid, liquid, and vapor phases and areas where solid and liquid, solid and vapor, or liquid and vapor coexist in equilibrium. A line on the surface called a triple line is where solid, liquid and vapor can all coexist in equilibrium. The critical point ...
This should be kept in mind when using cubic equations in calculations, e.g., of vapor-liquid equilibrium. In 1972 G. Soave [ 4 ] replaced the 1 T {\textstyle {\frac {1}{\sqrt {T}}}} term of the Redlich–Kwong equation with a function α ( T , ω ) involving the temperature and the acentric factor (the resulting equation is also known as the ...
The commonly known phases solid, liquid and vapor are separated by phase boundaries, i.e. pressure–temperature combinations where two phases can coexist. At the triple point, all three phases can coexist. However, the liquid–vapor boundary terminates in an endpoint at some critical temperature T c and critical pressure p c. This is the ...
The table above gives properties of the vapor–liquid equilibrium of anhydrous ammonia at various temperatures. The second column is vapor pressure in kPa. The third column is the density of the liquid phase. The fourth column is the density of the vapor. The fifth column is the heat of vaporization needed to convert one gram of liquid to vapor.
Archived from the original (PDF) on 27 September 2007 ... Distillation data. Vapor–liquid equilibrium for ethylene glycol/water [3] P = 760 mmHg BP temp. °C % by ...