Search results
Results From The WOW.Com Content Network
The Ford flathead V8 was licensed to other producers. It was used by Simca in France until 1961 and in Brazil until 1964 for cars and until 1990 in the Simca Unic Marmon Bocquet military truck. [6] In the United States, the flathead V8 was replaced by the more modern overhead-valve Ford Y-block engine in 1954.
The Ford Model T engine had one carburetor, a side-draft, single-venturi unit. Its choke and throttle valves were controlled manually; the latter was with a hand lever rather than a foot pedal. The carburetor had no accelerator pump. Various vendors supplied Ford with carburetors for the T engine, including Holley, Zenith, and Kingston.
The V8 was marketed as the Model 18 in its initial year, but was commonly known as the Ford V‑8. It had the new flathead V8 engine. The Model 18 was the first low-priced, mass-marketed car to have a V8 engine -- an important milestone in the American automotive industry. The 221 cu in (3.6 L) V8 was rated at 65 horsepower (48 kW; 66 PS), but ...
The Ford Sidevalve is a side valve (flathead engine) from the British arm of the Ford Motor Company, often also referred to as the "English Sidevalve". The engine had its origins in the 1930s Ford Model Y , and was made in two sizes, 933 cc (56.9 cu in) or "8 HP", and 1,172 cc (71.5 cu in) or "10 HP".
The first Y-block on Ford automobiles and F100 trucks was the 239 cu in (3,910 cc) version as released in 1954 with EBU casting numbers. The Y-block was the same displacement as the old Ford Flathead V8 that it replaced but with a bigger bore and a shorter stroke (3.5 x 3.1 in).
A crossflow T-head sidevalve engine The usual L-head arrangement Pop-up pistons may be used to increase compression ratio Flathead with Ricardo's turbulent head. A flathead engine, also known as a sidevalve engine [1] [2] or valve-in-block engine, is an internal combustion engine with its poppet valves contained within the engine block, instead of in the cylinder head, as in an overhead valve ...
The engine is Ford's 3.062-by-3.75-inch (77.8 by 95.3 mm), 221 in 3 (3,620 cm 3; 3.62 L) 90° flathead V8 Otto (spark ignition) engine. It is liquid-cooled, and consists of five main cast pieces made of a light metal alloy: the engine block with cast-in cylinders, the intake plenum, two flatheads, and a fairly expensive oilpan.
The Fork and Blade V8 used a novel approach for the piston connecting rods, which meant two connecting rods shared one bearing on the crankshaft, which allowed for a short crankshaft and a smaller overall engine size. 1932–1953 Flathead V8; 1940–1950 Ford GAA engine, exclusively for armored fighting vehicle military use