Ads
related to: gauge size chart nose ring length measurements conversionamazon.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
A gauge number denotes a thickness on a standardized scale which, for most purposes, starts at 20g (0.812 mm thick— often used for the posts for nose studs), and increases in thickness (as the gauge number decreases) to 0g, then 00g, and rarely goes any further as these thicknesses come closer and closer to 1 ⁄ 2 ″.
Ring sizes can be measured physically by a paper, plastic, or metal ring sizer (as a gauge) or by measuring the inner diameter of a ring that already fits. Ring sticks are tools used to measure the inner size of a ring, and are typically made from plastic, delrin, wood, aluminium, or of multiple materials. Digital ring sticks can be used for ...
Tapers come in a variety of sizes and are usually identified by the gauge of the large end. They can vary in length, but most tapers are about 2–3 inches (5.1–7.6 cm) long. Most tapers are made of stainless steel or acrylic and some have threads extending from the wide end to allow the attachment of barbell jewelry, to make insertion easier.
It was my belief that Swiss sizes are European sizes minus 40. For example a EU Size 54 is equivalent to CH size 14. EU sizes are based on the inner circumference. So EU size 54 has an inner circumference of 54mm. Therefore CH size 14 == 54mm. Looking at the conversion chart on this page, that isn't even close.
There are three main types of ring gauges: go, no go, and master or setting ring gauges. Go ring gauges provide a precision tool for production comparative gauging based on a fixed limit. Go gauges consist of a fixed limit gauge with a gauging limit based on the plus or minus tolerances of the inspected part. A go ring gauge's dimensions are ...
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.