Ads
related to: transfer case gear ratios
Search results
Results From The WOW.Com Content Network
Inside of a 231 New Process Gear transfer case. Part-time/Manual, shift on the fly. A transfer case is an intermediate gearbox that transfers power from the transmission of a motor vehicle to the driven axles of four-wheel-drive, all-wheel-drive, and other multi-axled on- and off-road machines.
A 2WD transmission found in Toyota Tacoma/Hilux 1996+, Toyota Prado .It came with two input shaft lengths pre- 1996 and 1996 and up (20mm longer) Ratios: First Gear: 3.830:1
The Dana 18 is a gear driven part-time transfer case. [2] Both the front and rear output shafts are offset towards the passenger side of the vehicle. Drive modes offered include 2-wheel high, part-time 4-wheel high, and part-time 4-wheel Low. All Dana 18 cases are cast iron and use the "Texas" bolt pattern with five bolts holding on the ...
Freedom Drive II uses the same hardware as the FDI system but adds a lower axle gear ratio in conjunction with the CVT to simulate the benefits of a low-range transfer case, giving a 19:1 overall gear ratio for off-road use. This function is an alternate program in the CVT and is not a transfer case function.
The A341F is an A340F with locking/unlocking transfer case differential to allow an AWD mode on the Sequoia. ... Same gear ratios as the AA80E but a shorter 3.133 ...
After its introduction in 1984, the Justy was also available with 4WD and thus a different gearbox. The gear ratios for this gearbox were altered slightly. In 1994 the normal/FWD gearbox was dropped; one could only get a 4WD gearbox by then. Gear ratios: 1st 3.071 2nd 1.695 3rd 1.137 4th .771 5th .631, Rev 3.461 Final 5.200
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation:
Muncie SM420 transmission — 4-speed manual used up to 1967, very similar to sm 465 except small changes to gear ratios and location of reverse. New Process Gear NP435 - 4-speed longitudinal transmission used in a select handful of 67-72 GM pickups