Ads
related to: pontiac throttle position sensor replacement
Search results
Results From The WOW.Com Content Network
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used. For example, an extra "closed throttle position ...
The throttle position sensor(s) are continually read and then the software makes appropriate adjustments to reach the desired amount of engine power. There are two primary types of Throttle Position Sensor (TPS): a potentiometer or a non-contact sensor Hall Effect sensor (magnetic device).
[citation needed] The electronic versions have a throttle position sensor that is mounted inside the carburetor body, actuated by the accelerator pump lever. Quadrajet carburetors have mechanical secondary throttle plates operated by a progressive linkage; the primaries open before the secondaries, and use on-demand air valve plates above the ...
The CCC system included the electronic Rochester 4-bbl E4ME Quadra-Jet, with computer-adjusted fuel metering on the primary venturis and a throttle position sensor allowing the CCC to calculate engine load. In the ignition system, CCC was fully responsible for the timing curve; mechanical and vacuum advances were eliminated from the distributor.
The Iron Duke engine (also called 151, 2500, Pontiac 2.5, and Tech IV) is a 151 cu in (2.5 L) straight-4 piston engine built by the Pontiac Motor Division of General Motors from 1977 until 1993. Originally developed as Pontiac's new economy car engine, it was used in a wide variety of vehicles across GM's lineup in the 1980s as well as supplied ...
Electronic throttle control, throttle position sensor fault or cruise control failure (see drive by wire) [11] Stuck throttle (unrelated to pedal position) [12] [13] Shorting of tin whiskers [14] [15] Diesel engine runaway: Diesel engine power is governed by the amount of fuel supplied. Excessive pressure in the crankcase can force mist of ...
Work Completed: Accelerator pedal position sensor replaced, throttle body refurbished (carbon track replaced with a magnet-based non contact system) air conditioning serviced; new heat exchanger and dryer fitted, engine oil and oil filter replaced, front track rod ends replaced, instrument binnacle fixed, mismatched tyres replaced and new ...
The 421.19 cu in (6.9 L) was introduced in 1961 as a dealer-installed Super Duty option for racing. Unlike previous enlargements of Pontiac V8s, it did not replace the 389. The first of the "big journal" Pontiac V8s, it had a bore and stroke of 4 + 3 ⁄ 32 in × 4 in (104.0 mm × 101.6 mm) and came with dual four-barrel carburetors.