Ads
related to: cisco ip route static
Search results
Results From The WOW.Com Content Network
Static routes, connected routes, and routes from dynamic configuration protocols can be redistributed by dynamic routing protocols. For instance, a router may have a static or connected route for a local network segment, which is then redistributed over dynamic routing protocols to enable connectivity to that network.
The administrator can arbitrarily reconfigure the administrative distances, which affects the ranking of the preferred routes by the routing process. On Cisco routers, static routes have an administrative distance of 1, making them preferred over routes issued by a dynamic routing protocol. The administrative distance is a value that is always ...
Each routing protocol contains loop-avoidance mechanisms, but the information needed for loops to be avoided is lost when routes are redistributed. For example, a distance-vector routing protocol may prevent loops by the "split-horizon" rule; that is to say, if a router learns a route from a particular interface it will not re-advertise the ...
On Cisco routers, the interface bandwidth is a configurable static parameter expressed in kilobits per second (setting this only affects metric calculation and not actual line bandwidth). Dividing a value of 10 7 kbit/s (i.e. 10 Gbit/s) by the interface bandwidth statement value yields a result that is used in the weighted formula. The ...
Router configuration rules may contain static routes. A static route minimally has a destination address, a prefix length or subnet mask, and a definition where to send packets for the route. That definition can refer to a local interface on the router, or a next-hop address that could be on the far end of a subnet to which the router is connected.
Static routes are routes that a network administrator manually configured. Routing tables are also a key aspect of certain security operations, such as unicast reverse path forwarding (uRPF). [ 2 ] In this technique, which has several variants, the router also looks up, in the routing table, the source address of the packet.
IP forwarding algorithms in most routing software determine a route through a shortest path algorithm. In routers, packets arriving at an interface are examined for source and destination addressing and queued to the appropriate outgoing interface according to their destination address and a set of rules and performance metrics.
It does this using internal pre-configured directives, called static routes, or by learning routes dynamically using a routing protocol. Static and dynamic routes are stored in the routing table. The control-plane logic then strips non-essential directives from the table and builds a forwarding information base (FIB) to be used by the ...