Search results
Results From The WOW.Com Content Network
An oil terminal (also called a tank farm, tankfarm, oil installation or oil depot) is an industrial facility for the storage of oil, petroleum and petrochemical products, and from which these products are transported to end users or other storage facilities. [1]
This may be by heat exchange with the incoming live crude and by cooling water in a heat exchanger. The dead, stabilized crude flows to tanks for storage or to a pipeline for transport to customers such as an oil refinery. [3] [4] [7] The stabilization tower may typically operate at approximately 50 to 200 psig (345 – 1378 kPa). [5]
A fuel tank (also called a petrol tank or gas tank) is a safe container for flammable fluids, often gasoline or diesel fuel. Though any storage tank for fuel may be so called, the term is typically applied to part of an engine system in which the fuel is stored and propelled ( fuel pump ) or released (pressurized gas) into an engine .
A small amount of fuel in the tank leaves pumps on the floor of the tank exposed to the air-fuel mixture, and an electric pump is a potential ignition source. The explosion of a Thai Airways International Boeing 737 in 2001 and a Philippine Airlines 737 in 1990 also occurred in tanks that had a small amount of residual fuel. These three ...
A bulk milk cooling tank is a storage tank located in a dairy farm's milkhouse used for cooling and holding fluid milk at a low temperature until it can be picked up by a milk hauler. Since milk leaves the udder at approximately 35 °C, milk tanks are needed to rapidly cool fresh raw milk to a storage temperature of 4 °C to 6 °C, thereby ...
Liquids thus recovered require stabilization to prevent excessive evaporation in the storage tanks. Metering separator The function of separating well fluids into oil, gas, and water and metering the liquids can be accomplished in one vessel. These vessels are commonly referred to as metering separators and are available for two-phase and three ...
Efficiency and range might be increased by a number of practical improvements. For example, combining the storage tank into the car chassis, higher pressure tanks, new rotary engines, and a more efficient heat exchanger. Also, the weight and cost of tanks and pneumatic parts might be reduced by using recycled and bio-based thermoplastics.
However, some storage is essential as the DM plant may be down for maintenance. For this purpose, a storage tank is installed from which DM water is continuously withdrawn for boiler make-up. The storage tank for DM water is made from materials not affected by corrosive water, such as PVC. The piping and valves are generally of stainless steel.