Ads
related to: engine tapping when accelerating battery keeps running
Search results
Results From The WOW.Com Content Network
Although the IAC is supposed to last the vehicle's lifetime, various reasons may cause it to fail/malfunction prematurely. The most common failure mode is partial/complete jamming of the actuator (due to dirt/dust or even oil) where it cannot be smoothly controlled. The result is an engine that fails to maintain idle RPM and frequently stalls.
Modern knock control-loop systems are able to adjust ignition timings for every cylinder individually. Depending on the specific engine the boost pressure is regulated simultaneously. This way performance is kept at its optimum while mostly eliminating the risk of engine damage caused by knock (e.g. when running on low octane fuel). [5]
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Dieseling or engine run-on is a condition that can occur in spark-plug-ignited, gasoline-powered internal combustion engines, whereby the engine keeps running for a short period after being turned off, drawing fuel through the carburetor, into the engine and igniting it without a spark.
This kind of electronic control is less common in piston-engined light fixed-wing aircraft and helicopters than in automobiles. This is due to the common configuration of a carbureted engine with a magneto ignition system that does not require electrical power generated by an alternator to run, which is considered a safety advantage. [12]
The throttle on a gasoline engine is typically a butterfly valve. In a fuel-injected engine, the throttle valve is placed on the entrance of the intake manifold, or housed in the throttle body. In a carbureted engine, it is found in the carburetor. When a throttle is wide open, the intake manifold is usually close to ambient atmospheric pressure.