Ads
related to: alternator repair plug harness connector pin code
Search results
Results From The WOW.Com Content Network
dynamo/alternator diode+ D- dynamo/alternator diode- DF dynamo field DF1 dynamo field 1 DF2 dynamo field 2 U, V, W AC three phase terminals Lights 54 brake lights 54g lights 54 55 fog light N 56 spot light 56a headlamp high beam and indicator light 56b low beam F 56d signal flash 57 parking lights 57a parking lights P 57L parking lights left PL 57R
Figure 1 – Essential Connector Parts for Bent Pin Analysis. In most pairs of mating connectors, one connector is fitted with an array of socket contacts and the other connector has a corresponding array of pin (or other shaped) contacts, as illustrated in Figure 1. These are sometimes called female and male contacts.
Three-phase plugs have a dimension of 35.4 (± 0.7) × 30 (± 0.7) mm. Pin length of the connector The pins are 19 mm (± 0.5 mm) long on all types. The length of the insulation on the connector pins is 8 mm (± 0.25 mm). Diameter of the pins and the openings The pins of the 10 A connector are 4 mm (± 0.06 mm) in diameter.
63 A plug with pilot contact. Connectors rated at 63 A and 125 A may optionally be equipped with a 6 mm pilot contact. This smaller pin in the centre of the connector is shorter than the others, designed to 'make' after all the other pins when connecting a plug and socket, and to 'break' first when disconnecting. It is used to switch off the load.
Connectors on this cable would be designated: 1A1W35P1; 1A1W35P2; ASME Y14.44-2008 continues the convention of Plug P and Jack J when assigning references for electrical connectors in assemblies where a J (or jack) is the more fixed and P (or plug) is the less fixed of a connector pair, without regard to the gender of the connector contacts.
The proximity pin, PP (also known as plug present), as shown in the SAE J1772 example pinout, describes the switch, S3, as being mechanically linked to the connector latch release actuator. During charging, the EVSE side connects the PP–PE loop via S3 and a 150 Ω R6; when opening the release actuator a 330 Ω R7 is added in the PP–PE loop ...