Search results
Results From The WOW.Com Content Network
High-speed impact takes its toll on all reed valves, with metal valves suffering in fatigue. The physical inertia of reed valves means that they are not as entirely precise in action as rotary valves, a rotary valve engine may run better than a reed valve engine at a small rpm range but the reed valve engine often runs better over a wider rpm ...
A Cox Babe Bee 0.049 in 3 (0.80 cm 3) reed valve engine, disassembled, uses glow-plug ignition. Its mass is 64 g. The reed valve is a simple but highly effective form of check valve commonly fitted in the intake tract of the piston-controlled port. It allows asymmetric intake of the fuel charge, improving power and economy, while widening the ...
A stroke is the action of a piston travelling the full length of its cylinder.In a two-stroke engine, one of the two strokes combines primarily the intake stroke and the combustion stroke, while the other stroke primarily combines the compression stroke and the exhaust stroke, though technically since both ports are exposed during both the combustion and compression strokes, some reversion ...
Leaf valves are commonly mounted in the intake port of most 2-stroke motorcycle engines. When the piston moves up in the cylinder, the valve opens and allows air and fuel to pass through the intake port and into the carburetor. When the piston moves down, the valve closes and the compressed air in the cylinder is forced out through the exhaust ...
Diagram of a crankcase scavenged valveless 2-stroke engine in operation. Some SI engines are crankcase scavenged and do not use poppet valves. Instead, the crankcase and the part of the cylinder below the piston is used as a pump. The intake port is connected to the crankcase through a reed valve or a rotary disk valve driven by the engine. For ...
Small boats with outboard engines and personal water crafts (PWC) tend to ingest water simply because they run in and around it. During a rollover, or when a wave washes over the craft, its engine can hydraulic, though severe damage is rare due to the special air intakes and low rotating inertia of small marine engines.
Like its 2- and 4-cylinder brethren, the Mark 75 featured internal reed valves. The reed valve blocks served as intermediate main bearings. Because the valves occupied space already necessary for the main bearings instead of mounting to an extension of the crankcase, crankcase volume was minimized, resulting in a higher crankcase compression ...
Basic parts of an outboard motor. An outboard motor is a propulsion system for boats, consisting of a self-contained unit that includes engine, gearbox and propeller or jet drive, designed to be affixed to the outside of the transom. They are the most common motorised method of propelling small watercraft.