Search results
Results From The WOW.Com Content Network
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
This was Chevrolet's second 4.3L power plant; four other Chevrolet engines displaced 4.3L: the Vortec 4300 (a V6 based on the Chevrolet 350 cu in (5.7 L), with two cylinders removed), the original 265 cu in (4.3 L) V8 in 1954, a bored version of the stovebolt-era 235 inline six displacing 261 cu in (4.3 L), and a derivative of the Generation II ...
The Chevrolet small-block engine refers to one of the several gasoline-powered vehicle engines manufactured by General Motors. These include: The first or second generation of non-LS Chevrolet small-block engines; The third, fourth, or fifth generation of LS-based GM engines; The Chevrolet Gemini small-block engine
GM's German subsidiary, Opel, relies on a range of three-, four- and six-cylinder gasoline and diesel engines. A survey [citation needed] of their range shows a reliance on petrol and diesel four-cylinders, and in 2014, there was only one 3-cylinder engine and one 6 cylinder engine in service in Opel's passenger car range.
Straight-six engines typically use a firing order of 1-5-3-6-2-4. However, a firing order of 1-2-4-6-5-3 is common on medium-speed marine engines. V6 engines with an angle of 90 degrees between the cylinder banks have used a firing orders of R1-L2-R2-L3-L1-R3 or R1-L3-R3-L2-R2-L1. Several V6 engines with an angle of 60 degrees have used a ...
1970–1972 LT-1 – Chevrolet Generation I Small-Block; 1992–1997 LT1 – GM Generation II Small-Block; 2013–(current) LT1 - GM Generation V Small-Block.
They used Pontiac's 347-cubic-inch (5.7 L) in 1957. For 1958, GMC reduced the bore of Pontiac's 370-cubic-inch (6.1 L) to 3.875 in (98.4 mm), resulting in a displacement of 336-cubic-inch (5.5 L). (In Canada, however, GMC used the Chevrolet small-block engine rather than the Pontiac.) For 1959, as the Pontiac engine's stroke was lengthened to 3 ...
The traditional five-bolt pentagonal cylinder head pattern was replaced with a square four-bolt design (much like the 1964–1990 Oldsmobile V8), and the pistons are of the flat-topped variety (in the LS1, LS2, LS3, LS6, LS7, LQ9, and L33), while all other variants, including the new LS9 and LQ4 truck engine, received a dished version of the GM ...