Ads
related to: removing bottom bracket on bike chain lock length
Search results
Results From The WOW.Com Content Network
The plug is machined to accept a typical bottom bracket, but offset from the center of the plug, so that by rotating the plug, the location of the bottom bracket (and hence the chain tension) may be adjusted (fore and aft to tension the chain, the upper or lower eccentric position for a given chain length can be chosen to fine tune bottom ...
A chain tool or chain splitter is used to 'break' a chain, in order to remove it from a bike or remove links, or to put a chain back together. A crank extractor is used to pull the crank off the bottom bracket spindle. A pedal wrench removes the pedals from the bicycle. It is also usually possible to use a common spanner in the correct size for ...
Bicycle chains Roller chain and sprocket. A bicycle chain is a roller chain that transfers power from the pedals to the drive-wheel of a bicycle, thus propelling it.Most bicycle chains are made from plain carbon or alloy steel, but some are nickel-plated to prevent rust, or simply for aesthetics.
Chainstay: a pair of tubes on a bicycle frame that runs from the bottom bracket to the rear fork ends; Chain tensioner: a device to maintain proper chain tension; Chaintug: a device to aid in setting the proper chain tension; Cluster: a bicycle cogset, either a freewheel, or cassette
A typical chain tool. With a chain placed on the central sprocket, the screw is turned until a pin is pushed from the linkage. A chain tool is a small mechanical device used to "break" a bicycle chain in such a way that it can be mended with the same tool. A bicycle chain has links and plates that are pinned together; these pins can be pushed ...
Crank length is measured from the center of the pedal spindle to the center of the bottom bracket spindle or axle. The larger bicycle component manufacturers typically offer crank lengths for adult riders from 165 to 180 mm (6.5 to 7.1 in) long in 2.5 mm (0.098 in) increments, with 170 mm (6.7 in) cranks being the most common size.
The mechanism was invented in 1927 by Tullio Campagnolo, an Italian bicycle racer. He was frustrated when he attempted to change gears during a race. At the time there was but one cog on each side of the rear hub, so gear changes necessitated stopping, removing the rear wheel, flipping it over horizontally so that the opposite cog is engaged by the chain, and finally reinstalling the wheel.
Simple platform bicycle pedal. The pedal is the part of a bicycle that the rider pushes with their foot to propel the vehicle. It provides the connection between the cyclist's foot or shoe and the crank allowing the leg to turn the bottom bracket spindle and propel the bicycle's wheels.