Search results
Results From The WOW.Com Content Network
Engine displacement is calculated based on bore, stroke length and the number of cylinders: [1] displacement = π ( 1 / 2 × bore ) 2 × stroke × n cylinders. The stroke ratio, determined by dividing the bore by the stroke, traditionally indicated whether an engine was designed for power at high engine speeds or torque at lower engine ...
An engine is described as oversquare or short-stroke if its cylinders have a greater bore diameter than its stroke length, giving a bore/stroke ratio greater than 1:1. An oversquare engine allows for more and larger valves in the head of the cylinder, higher possible rpm by lowering maximum piston speed, and lower crank stress due to the lower ...
The induction stroke is the first phase in a four-stroke (e.g. Otto cycle or Diesel cycle) engine.It involves the downward movement of the piston, creating a partial vacuum that draws an air-fuel mixture (or air alone, in the case of a direct injection engine) into the combustion chamber.
Similar to U engines, H engines consist of two separate flat engines joined by gears or chains. H engines have been produced with between 4 and 24 cylinders. An opposed-piston engine is similar to a flat engine in that pairs of pistons are co-axial but rather than sharing a crankshaft, instead share a single combustion chamber per pair of ...
Animation of a two-stroke engine. A two-stroke (or two-stroke cycle) engine is a type of internal combustion engine that completes a power cycle with two strokes of the piston (one up and one down movement) in one revolution of the crankshaft in contrast to a four-stroke engine which requires four strokes of the piston in two crankshaft revolutions to complete a power cycle.
The distance between the axis of the crankpins and the axis of the crankshaft determines the stroke length of the engine. [1] Most modern car engines are classified as "over square" or short-stroke, [citation needed] wherein the stroke is less than the diameter of the cylinder bore. A common way to increase the low-RPM torque of an engine is to ...
The Generation III 5.7L (LS1 and LS6) engines share little other than similar displacement, external dimensions, and rod bearings, with its predecessor (LT1). It is an all-aluminum 5,665 cc (5.7 L; 345.7 cu in) pushrod engine with a bore and stroke of 99 mm × 92 mm (3.898 in × 3.622 in). [44]
A stroke is the action of a piston travelling the full length of its cylinder.In a two-stroke engine, one of the two strokes combines primarily the intake stroke and the combustion stroke, while the other stroke primarily combines the compression stroke and the exhaust stroke, though technically since both ports are exposed during both the combustion and compression strokes, some reversion ...