Ad
related to: cross lap joints woodworking
Search results
Results From The WOW.Com Content Network
Left to right: Half lap, mitred half lap, cross lap and dovetail lap. A lap joint or overlap joint is a joint in which the members overlap. Lap joints can be used to join wood, plastic, or metal. A lap joint can be used in woodworking for joining wood together. A lap joint may be a full lap or half lap.
Dowel joint: The end of a piece of wood is butted against another piece of wood. This is reinforced with dowel pins. This joint is quick to make with production line machinery and so is a very common joint in factory-made furniture. Cross dowel joint: A threaded metal dowel is inserted into a drilled slot. A screw is then inserted through an ...
A halved joint is a woodworking joint in which the two members are joined by removing material from each at the point of intersection so that they overlap. The halved joint is differentiated from the lap joint in that the members are joined on edge, rather than on flat.
A joint technique most commonly used in woodworking joinery. Noted for its resistance to being pulled apart (tensile strength), the dovetail joint is commonly used to join the sides of a drawer to the front. dowel A cylindrical piece of wood used as a pin for securing a joint. drawknife A cutting tool with two handles used for cutting large ...
A splice joint is a method of joining two members end to end in woodworking. [1] The splice joint is used when the material being joined is not available in the length required. It is an alternative to other joints such as the butt joint and the scarf joint. Splice joints are stronger than unreinenforced butt joints and have the potential to be ...
A dovetail joint or simply dovetail is a joinery technique most commonly used in woodworking joinery (carpentry), including furniture, cabinets, [1] log buildings, and traditional timber framing. Noted for its resistance to being pulled apart, also known as tensile strength , the dovetail joint is commonly used to join the sides of a drawer to ...
Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles
A dado (US and Canada, / ˈ d eɪ d oʊ /), housing (UK) or trench (Europe) is a slot or trench cut into the surface of a piece of machinable material, usually wood. When viewed in cross-section, a dado has three sides. A dado is cut across, or perpendicular to, the grain and is thus differentiated from a groove which is cut with, or parallel ...