Search results
Results From The WOW.Com Content Network
IBM used the terms Binary-Coded Decimal Interchange Code (BCDIC, sometimes just called BCD), for 6-bit alphanumeric codes that represented numbers, upper-case letters and special characters. Some variation of BCDIC alphamerics is used in most early IBM computers, including the IBM 1620 (introduced in 1959), IBM 1400 series , and non- decimal ...
In computer science, the double dabble algorithm is used to convert binary numbers into binary-coded decimal (BCD) notation. [ 1 ] [ 2 ] It is also known as the shift-and-add -3 algorithm , and can be implemented using a small number of gates in computer hardware, but at the expense of high latency .
The Intel BCD opcodes are a set of six x86 instructions that operate with binary-coded decimal numbers. The radix used for the representation of numbers in the x86 processors is 2. This is called a binary numeral system. However, the x86 processors do have limited support for the decimal numeral system.
Technically, binary-coded decimal describes the encoding of decimal numbers where each decimal digit is represented by a fixed number of bits, usually four. With the introduction of the IBM card in 1928, IBM created a code [a] capable of representing alphanumeric information, [2] later adopted by other manufacturers.
Binary-coded decimal (BCD) is a binary encoded representation of integer values that uses a 4-bit nibble to encode decimal digits. Four binary bits can encode up to 16 distinct values; but, in BCD-encoded numbers, only ten values in each nibble are legal, and encode the decimal digits zero, through nine.
The full decimal significand is then obtained by concatenating the leading and trailing decimal digits. The 10-bit DPD to 3-digit BCD transcoding for the declets is given by the following table. b 9 … b 0 are the bits of the DPD, and d 2 … d 0 are the three BCD digits.
A two-out-of-five code is a constant-weight code that provides exactly ten possible combinations of two bits, and is thus used for representing the decimal digits using five bits. [1] Each bit is assigned a weight, such that the set bits sum to the desired value, with an exception for zero. According to Federal Standard 1037C:
Six-bit BCD code was the adaptation of the punched card code to binary code. IBM applied the terms binary-coded decimal and BCD to the variations of BCD alphamerics used in most early IBM computers, including the IBM 1620, IBM 1400 series, and non-decimal architecture members of the IBM 700/7000 series.