Ad
related to: dana 300 low range gear ratio
Search results
Results From The WOW.Com Content Network
The output for the front drive shaft is on the right side and the rear output is in line with the input. This enables 2-wheel High to be direct-drive, which is quieter. Otherwise the Dana 20 offers the same drive modes as the Dana 18. Its low range has a ratio of 2.03:1. The Dana 20 is generally compatible with the "big hole" Dana 18.
When in "4-Low" mode the front and rear axles are locked together and power is sent to all four-wheels through the power transfer unit although no low range gear reduction occurs. Active Drive low relies on shorter axle gear ratios while holding first gear in the ZF9HP transmission to achieve a crawl ratio of 20:1; similar in effect to Freedom ...
It had a 126-inch (3,200 mm) up to a 147" wheelbase chassis and featured the 230 cubic-inch flathead inline-six engine, a 4-speed manual transmission, a two-speed 1.96-1 ratio low range transfer case for part time 4-wheel drive with a power take off (PTO) which would send power front or rear for operating auxiliary equipment, and 9.00/16-8 ply ...
The final drive ratios of the CJ-7 were different for each type of engine: the 145 cu in (2.4 L) diesel was mated to the 4.10 ratio axle (in both Renegade and Laredo), while the 258 cubic-inch straight six and 150 cubic-inch four-cylinder used 3.73 and AMC V8 304-powered models (produced 1976–1981, which became part of the Golden Eagle ...
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation:
The Dana S110 is a full floating, drop-out axle. Dana S110 axles are a step up in overall strength compared to the Dana 80. Ford started using this axle in 2005 model F-450 and F-550 trucks. Replacing the Dana 80 in some class 4 trucks, and the Dana S 135 in the rest of the trucks. Dodge started using the Dana S110 in their 2008 model 4500 and ...
After its introduction in 1984, the Justy was also available with 4WD and thus a different gearbox. The gear ratios for this gearbox were altered slightly. In 1994 the normal/FWD gearbox was dropped; one could only get a 4WD gearbox by then. Gear ratios: 1st 3.071 2nd 1.695 3rd 1.137 4th .771 5th .631, Rev 3.461 Final 5.200
Dana 61 axle tag showing 3.73:1 ratio [1] The Dana 61 was made in semi-float and full-float axles for select 4×2 and 4x4 Ford 3 ⁄ 4-ton and 1 Ton Pickups and Vans from 1974 to 1987. A Dana 61 front axle was selectively used in Dodge 4×4 3 ⁄ 4-ton and 1 Ton pickups from 1987 to 1993. Although 3.07:1 and 3.31:1 gear sets are common for a ...