Ad
related to: how to stop realtek from muting audio cable on hpwiki-drivers.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
A headphone cable with microphone, a wired headset, or a wired microphone - More expensive and will provide just one blocking plug. It's possible that microphone connectors without a microphone circuit like the above solutions offer low security, because when you plug a connector that has no microphone or microphone circuit, software has the ...
Avance Logic was acquired by Realtek as early as 1995 and was an independent subsidiary until the end of 2002, when the company was integrated into Realtek. Realtek's Audio Solutions are based on Avance Logic technology, which can also be recognized by the prefixes "ALG" (Avance Logic Graphics) and "ALS" (Avance Logic Sound).
Typical live use of a multicore (thick cable on stage) Multicores usually create a link between the stage and sound desk, or live room and control room.When used in sound reinforcement, the multicore cable runs from the stage box or microphone splitter to the front-of-house sound desk, where it connects to a mixing console. [2]
Virtual Audio Cable is a software product based on WDM multimedia driver that allows a user to transfer audio streams from one application to another. Any application is able to send an audio stream to the input side of a "virtual cable" while a corresponding application can receive this stream from the output side.
Headphone and earphone jacks on a wide range of equipment. 6.35 mm (1 ⁄ 4 in) plugs are common on home and professional audio equipment, while 3.5 mm plugs are nearly universal for portable audio equipment and headphones. 2.5 mm plugs are not as common, but are used on communication equipment such as cordless phones, mobile phones, and two ...
S/PDIF and TOSLINK connectors on a piece of audio equipment. S/PDIF (Sony/Philips Digital Interface) [1] [2] is a type of digital audio interface used in consumer audio equipment to output audio over relatively short distances. The signal is transmitted over either a coaxial cable using RCA or BNC connectors, or a fibre-optic cable using ...
Skin effect in audio cables is the tendency for high frequency signals to travel more on the surface than in the center of the conductor, as if the conductor were a hollow metal pipe. [3] This tendency, caused by self-inductance, makes the cable more resistant at higher frequencies, diminishing its ability to transmit high frequencies with as ...
To avoid this, some motherboards allow choosing between HDA and AC'97 front panels in the BIOS. Even though the actual audio hardware is HD Audio, the BIOS can be manipulated to allow the use of an AC'97 front panel. Likewise, some modern enclosures have both an "AC'97" and an "HDA" plug at the end of the front-panel audio cable. [citation needed]