Ads
related to: metal finish chart
Search results
Results From The WOW.Com Content Network
It is produced by polishing the metal with a 120–180 grit belt or wheel finish and then softened with an 80–120 grit greaseless compound or a medium non woven abrasive belt or pad. #4 Dairy or sanitary finish. This finish is commonly used for the medical and food industry and almost exclusively used on stainless steel.
Surface finish, also known as surface texture or surface topography, is the nature of a surface as defined by the three characteristics of lay, surface roughness, and waviness. [1] It comprises the small, local deviations of a surface from the perfectly flat ideal (a true plane ).
Surface roughness, often shortened to roughness, is a component of surface finish (surface texture). It is quantified by the deviations in the direction of the normal vector of a real surface from its ideal form. If these deviations are large, the surface is rough; if they are small, the surface is smooth.
Mill finish is the surface texture (or finish) of metal after it exits a rolling mill, extrusion die, or drawing processes, including sheet, bar, plate, or structural shapes. This texture is usually rough and lacks lustre; it may have spots of oxidation or contamination with mill oil.
The condition of the material at hand determines what type of abrasive will be applied. The first stage, if the material is unfinished, starts with a rough abrasive (perhaps 60 or 80 grit) and each subsequent stage uses a finer abrasive, such as 120, 180, 220/240, 320, 400 and higher grit abrasives, until the desired finish is achieved.
The dual finishing process uses the best each process has to offer, anodizing with its hard wear resistance and chromate conversion coating with its electrical conductivity. The process steps can typically involve chromate conversion coating the entire component, followed by a masking of the surface in areas where the chromate coating must ...
Turned, ground, and polished (TGP) is a classification of finishing processes often used for metal shafting. Turning (on a lathe) creates straight round bars without the strain induced by cold drawing, while grinding and polishing improves the surface finish and roundness for high dimensional accuracy. [1]
Brushed stainless steel or dull polished metal [1] is metal with a unidirectional satin finish. It is produced by polishing the metal with a 120–180 grit belt or wheel then softening with an 80–120 grit greaseless compound or a medium non-woven abrasive belt or pad. Commonly brushed metals include stainless steel, aluminium and nickel.