Search results
Results From The WOW.Com Content Network
Fault detection, isolation, and recovery (FDIR) is a subfield of control engineering which concerns itself with monitoring a system, identifying when a fault has occurred, and pinpointing the type of fault and its location. Two approaches can be distinguished: A direct pattern recognition of sensor readings that indicate a fault and an analysis ...
Before detailed analysis takes place, ground rules and assumptions are usually defined and agreed to. This might include, for example: Standardized mission profile with specific fixed duration mission phases; Sources for failure rate and failure mode data; Fault detection coverage that system built-in test will realize
Failure Reporting (FR). The failures and the faults related to a system, a piece of equipment, a piece of software or a process are formally reported through a standard form (Defect Report, Failure Report). Analysis (A). Perform analysis in order to identify the root cause of failure. Corrective Actions (CA).
All the potential causes for a failure mode should be identified and documented. This should be in technical terms. Examples of causes are: Human errors in handling, Manufacturing induced faults, Fatigue, Creep, Abrasive wear, erroneous algorithms, excessive voltage or improper operating conditions or use (depending on the used ground rules).
Failure analysis is the process of collecting and analyzing data to determine the cause of a failure, often with the goal of determining corrective actions or liability.. According to Bloch and Geitner, ”machinery failures reveal a reaction chain of cause and effect… usually a deficiency commonly referred to as the symptom…”
A fault tree diagram. Fault tree analysis (FTA) is a type of failure analysis in which an undesired state of a system is examined. This analysis method is mainly used in safety engineering and reliability engineering to understand how systems can fail, to identify the best ways to reduce risk and to determine (or get a feeling for) event rates of a safety accident or a particular system level ...
The next 140 pages give an overview of the modeling techniques and how they should be applied. The last 160 pages give an example of the process in action. Some of the methods covered: Functional Hazard Assessment (FHA) Preliminary System Safety Assessment (PSSA) System Safety Assessment (SSA) Fault Tree Analysis (FTA)
ATPG (acronym for both automatic test pattern generation and automatic test pattern generator) is an electronic design automation method or technology used to find an input (or test) sequence that, when applied to a digital circuit, enables automatic test equipment to distinguish between the correct circuit behavior and the faulty circuit behavior caused by defects.