Search results
Results From The WOW.Com Content Network
The grain per gallon (gpg) is a unit of water hardness defined as 1 grain (64.8 milligrams) of calcium carbonate dissolved in 1 US gallon of water (3.785412 L). It translates into 1 part in about 58,000 parts of water or 17.1 parts per million (ppm). Also called Clark degree (in terms of an imperial gallon).
0.1 × ( 12 ÷ 8 ) = 0.15 grain per dscf when corrected to a gas having a specified reference CO 2 content of 12 volume %. Notes: Although ppmv and grains per dscf have been used in the above examples, concentrations such as ppbv (i.e., parts per billion by volume), volume percent, grams per dscm and many others may also be used.
[14] [15] Otherwise, water hardness is measured in the dimensionless unit of parts per million (ppm), numerically equivalent to concentration measured in milligrams per litre. [14] [15] One grain per U.S. gallon is approximately 17.1 ppm. [14] [note 1] Soft water contains 1–4 gpg of calcium carbonate equivalents, while hard water contains 11 ...
Water hardness is often not expressed as a molar concentration, but rather in various units, such as degrees of general hardness , German degrees (°dH), parts per million (ppm, mg/L, or American degrees), grains per gallon (gpg), English degrees (°e, e, or °Clark), or French degrees (°fH, °f or °HF; lowercase f is used to prevent ...
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
In water testing hardness is often measured in parts per million (ppm), where one part per million is defined as one milligram of calcium carbonate (CaCO 3) per litre of water. Consequently, 1 dGH corresponds to 10 ppm CaO but 17.848 ppm CaCO 3 which has a molar mass of 100.09 g/mol.
A variety of hardness-testing methods are available, including the Vickers, Brinell, Rockwell, Meyer and Leeb tests. Although it is impossible in many cases to give an exact conversion, it is possible to give an approximate material-specific comparison table for steels.
Carbonate hardness is a measure of the concentration of carbonates such as calcium carbonate (CaCO 3) and magnesium carbonate (MgCO 3) per volume of water. As a unit 1 dKH is the same as 1 °dH which is equal to approximately 0.1786 mmol/L or 10.02 milligrams (mg) of calcium carbonate per litre of water, i.e. 17.86 ppm. [citation needed]