Search results
Results From The WOW.Com Content Network
The Intel RAID ROM is the firmware in the motherboard BIOS that is used to create the RAID array. Note: The RST drivers can be used for RAID and also on a single drive as it contains an AHCI driver. There is a bug in the version 12.5.0.1066 RST driver, which cause TRIM commands not to pass through the RAID driver to the drives.
RAID 5E, RAID 5EE, and RAID 6E (with the added E standing for Enhanced) generally refer to variants of RAID 5 or 6 with an integrated hot-spare drive, where the spare drive is an active part of the block rotation scheme. This spreads I/O across all drives, including the spare, thus reducing the load on each drive, increasing performance.
It often implements hardware RAID, thus it is sometimes referred to as RAID controller. It also often provides additional disk cache . Disk array controller is often ambiguously shortened to disk controller which can also refer to the circuitry responsible for managing internal disk drive operations.
RAID (/ r eɪ d /; redundant array of inexpensive disks or redundant array of independent disks) [1] [2] is a data storage virtualization technology that combines multiple physical data storage components into one or more logical units for the purposes of data redundancy, performance improvement, or both.
Diagram of a RAID 1 setup. RAID 1 consists of an exact copy (or mirror) of a set of data on two or more disks; a classic RAID 1 mirrored pair contains two disks.This configuration offers no parity, striping, or spanning of disk space across multiple disks, since the data is mirrored on all disks belonging to the array, and the array can only be as big as the smallest member disk.
RAID 10 is distinct from RAID 0+1, which consists of a top-level RAID 1 mirror composed of high-performance RAID 0 stripes directly across the physical hard disks. A single-drive failure in a RAID 10 configuration results in one of the lower-level mirrors entering degraded mode , but the top-level stripe performing normally (except for the ...
The BIOS cannot be configured for both RAID and ATAPI functioning at once, so users may be prevented by a manufacturer's decision from changing between these modes. The IT8212F is, according to ITE's Preliminary Specification V0.3, compliant with the ATAPI-6 specification, supporting transfer modes PIO modes 0,1,2,3 and 4, DMA modes 0,1 and 2 ...
Intel recommends choosing RAID mode on their motherboards (which also enables AHCI) rather than AHCI/SATA mode for maximum flexibility. [3] Legacy mode is a software backward-compatibility mechanism intended to allow the SATA controller to run in legacy operating systems which are not SATA-aware or where a driver does not exist to make the ...