Search results
Results From The WOW.Com Content Network
More generally encountered is the traditional unit of μS/cm. The commonly used standard cell has a width of 1 cm [clarify], and thus for very pure water in equilibrium with air would have a resistance of about 10 6 ohms, known as a megohm. Ultra-pure water could achieve 18 megohms or more. Thus in the past, megohm-cm was used, sometimes ...
The siemens (symbol: S) is the unit of electric conductance, electric susceptance, and electric admittance in the International System of Units (SI). Conductance, susceptance, and admittance are the reciprocals of resistance, reactance, and impedance respectively; hence one siemens is equal to the reciprocal of one ohm (Ω −1) and is also referred to as the mho.
where is the length of the conductor, measured in metres (m), A is the cross-sectional area of the conductor measured in square metres (m 2), σ is the electrical conductivity measured in siemens per meter (S·m −1), and ρ is the electrical resistivity (also called specific electrical resistance) of the material, measured in ohm-metres (Ω ...
The resistivity can be expressed using the SI unit ohm metre (Ω⋅m) — i.e. ohms multiplied by square metres (for the cross-sectional area) then divided by metres (for the length). Both resistance and resistivity describe how difficult it is to make electrical current flow through a material, but unlike resistance, resistivity is an ...
Because the values of the constants are quite small, it is common for manufacturers to quote them per kilometre rather than per metre; in the English-speaking world "per mile" can also be used. [1] [2] The word "constant" can be misleading. It means that they are material constants; but they may vary with frequency.
The units of specific contact resistivity are typically therefore in ohm-square metre, or Ω⋅m 2. When the current is a linear function of the voltage, the device is said to have ohmic contacts . Inductive and capacitive methods could be used in principle to measure an intrinsic impedance without the complication of contact resistance.
~ 10 −3 s: Used to measure the time between alternating power cycles. Also a casual term for a short period of time. centisecond: 10 −2 s: One hundredth of a second. decisecond: 10 −1 s: One tenth of a second. second: 1 s: SI base unit for time. decasecond: 10 s: Ten seconds (one sixth of a minute) minute: 60 s: hectosecond: 100 s ...
≡ 1 cm/s 2 = 10 −2 m/s 2: inch per minute per second: ipm/s ≡ 1 in/(min⋅s) = 4.2 3 × 10 −4 m/s 2: inch per second squared: ips 2: ≡ 1 in/s 2 = 2.54 × 10 −2 m/s 2: knot per second: kn/s ≡ 1 kn/s ≈ 5.1 4 × 10 −1 m/s 2: metre per second squared (SI unit) m/s 2: ≡ 1 m/s 2 = 1 m/s 2: mile per hour per second: mph/s ≡ 1 mi ...