When.com Web Search

  1. Ads

    related to: gel filled telephone splice connectors parts diagram printable chart

Search results

  1. Results From The WOW.Com Content Network
  2. Icky-pick - Wikipedia

    en.wikipedia.org/wiki/Icky-pick

    The thick gel stains clothing and hands and is very difficult to remove. When fiber-optic cables are to be spliced, the gel must be removed with solvents and swabs to prevent fouling of the splice. Paint thinner or charcoal starter is a frequently used and commonly available remover and clean-up agent.

  3. Twist-on wire connector - Wikipedia

    en.wikipedia.org/wiki/Twist-on_wire_connector

    Special gel-filled connectors must be used. Twist-on wire connectors are not generally recommended for use with aluminum wire in the United States. [ 1 ] The U.S. Consumer Product Safety Commission disapproves wire nuts for aluminum wire; instead, special crimp connectors are called for, and as of 2011 the CPSC asserted qualified, second ...

  4. Telephone jack and plug - Wikipedia

    en.wikipedia.org/wiki/Telephone_jack_and_plug

    For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...

  5. Category:Telephone connectors - Wikipedia

    en.wikipedia.org/wiki/Category:Telephone_connectors

    Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Pages for logged out editors learn more

  6. Electrical connector - Wikipedia

    en.wikipedia.org/wiki/Electrical_connector

    [6]: 56 (e.g. pin headers, screw terminals, board-to-board connectors) Splice or butt connectors (primarily insulation displacement connectors) that permanently join two lengths of wire or cable; In computing, electrical connectors are considered a physical interface and constitute part of the physical layer in the OSI model of networking.

  7. Filled cable - Wikipedia

    en.wikipedia.org/wiki/Filled_cable

    In telecommunications, a filled cable is a cable that has a non-hygroscopic material, usually a gel called icky-pick, inside the jacket or sheath.The nonhygroscopic material fills the spaces between the interior parts of the cable, preventing moisture from entering minor leaks in the sheath and migrating inside the cable.

  8. IDC (electrical connector) - Wikipedia

    en.wikipedia.org/wiki/IDC_(electrical_connector)

    Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

  9. 1A2 Key Telephone System - Wikipedia

    en.wikipedia.org/wiki/1A2_Key_Telephone_System

    The Call Director model telephone had over 30 line key positions, and used 100 pairs on four connectors. The keyset cables were typically routed to a wiring closet or wiring panel where the Key Service Unit (KSU) was installed and were terminated on a 66 type punch block , typically a model 66M1-50.

  1. Ad

    related to: gel filled telephone splice connectors parts diagram printable chart