Search results
Results From The WOW.Com Content Network
Fuel temperature coefficient of reactivity is the change in reactivity of the nuclear fuel per degree change in the fuel temperature. The coefficient quantifies the amount of neutrons that the nuclear fuel (such as uranium-238 ) absorbs from the fission process as the fuel temperature increases.
Doppler broadening, the physical phenomenon driving the fuel temperature coefficient of reactivity also been used as a design consideration in high-temperature nuclear reactors. In principle, as the reactor fuel heats up, the neutron absorption spectrum will broaden due to the relative thermal motion of the fuel nuclei with respect to the neutrons.
The image shows a periodic table extract with the electronegativity values of metals. [12] Wulfsberg [13] distinguishes: very electropositive metals with electronegativity values below 1.4 electropositive metals with values between 1.4 and 1.9; and electronegative metals with values between 1.9 and 2.54.
Reactivity in its most general sense would not be measured in dollars or cents. This is because k eff measures the total value of reactivity, a summation of the reactivity of both the prompt and delayed neutrons. However, reactivity in dollars is dependent on the delayed neutron fraction (β eff). [2] Reactivity in dollars = ρ / β eff
List of chemical elements — with basic properties like standard atomic weight, m.p., b.p., abundance; Abundance of the chemical elements; Abundances of the elements (data page) — Earth's crust, sea water, Sun and Solar System
An element–reaction–product table is used to find coefficients while balancing an equation representing a chemical reaction. Coefficients represent moles of a substance so that the number of atoms produced is equal to the number of atoms being reacted with. [1] This is the common setup: Element: all the elements that are in the reaction ...
The Doppler coefficient, which would have automatically reduced the neutron multiplication as the temperature increased, was relied upon to limit the power in the event of criticality. [1] If, contrary to all expectations, the plant had gotten out of control, the cadmium piece, which acted as a neutron absorber , would have been thrown into the ...
The change in reactivity caused by a change of voids inside the reactor is directly proportional to the void coefficient. A positive void coefficient means that the reactivity increases as the void content inside the reactor increases due to increased boiling or loss of coolant; for example, if the coolant acts predominantly as neutron absorber.