Search results
Results From The WOW.Com Content Network
A group of tell-tales showing lights for "brake fluid", "stop lamp" and "check engine" Graphical tell-tales. A tell-tale, sometimes called an idiot light [1] or warning light, is an indicator of malfunction or operation of a system, indicated by a binary (on/off) illuminated light, symbol or text legend.
Early versions of OBD would simply illuminate a tell-tale light if a problem was detected, but would not provide any information as to the nature of the problem. Modern OBD implementations use a standardized digital communications port to provide real-time data and diagnostic trouble codes which allow malfunctions within the vehicle to be ...
Telltale or tell-tale may refer to: Advisory devices in vehicles: Tell-tale (spacecraft), a status indicator in a spacecraft control system; Tell-tale (sailing), a piece of fabric attached as a guide for adjusting a sail; Tell-tale (bridges), cords or chains suspended from bridges to warn vehicle drivers of low clearance
For premium support please call: 800-290-4726 more ways to reach us
Tire-pressure gauge; V. Vacuum gauge This page was last edited on 13 July 2023, at 18:52 (UTC). Text is available under the Creative Commons Attribution ...
Strain-Gauge: Strain gauge based pressure sensors also use a pressure sensitive element where metal strain gauges are glued on or thin-film gauges are applied on by sputtering. This measuring element can either be a diaphragm or for metal foil gauges measuring bodies in can-type can also be used.
A tell-tale warning of a low clearance over a road. A tell-tale, also known as a bridge warning, is a series of ropes suspended over railway tracks to give warning to the engineer, and more importantly the brakeman who may be scampering across the tops of the cars, that the train is approaching a low-clearance obstacle, such as a tunnel or a bridge.
Further, the vacuum in the gauge eventually deteriorates due to slow diffusion of gases through the mercury, making the device inaccurate. [8] In 1938, Adolph Zimmerli (1886–1967) [9] invented a gauge that overcame the filling problems, at least for pressures below ambient pressure. [10] Zimmerli's gauge consists of three relatively wide columns.