Search results
Results From The WOW.Com Content Network
IPOP (IP-Over-P2P) is an open-source user-centric software virtual network allowing end users to define and create their own virtual private networks (VPNs). IPOP virtual networks provide end-to-end tunneling of IP or Ethernet over “TinCan” links setup and managed through a control API to create various software-defined VPN overlays.
OpenConnect is a free and open-source cross-platform multi-protocol virtual private network (VPN) client software which implement secure point-to-point connections. The OpenConnect client supports the following VPN protocols: Cisco AnyConnect; Juniper Secure Connect (since 7.05) [3] Palo Alto Networks GlobalProtect (since 8.00) [4]
WireGuard is a communication protocol and free and open-source software that implements encrypted virtual private networks (VPNs). [5] It aims to be lighter and better performing than IPsec and OpenVPN, two common tunneling protocols. [6]
A server using protocol SOCKS4a must check the DSTIP in the request packet. If it represents address 0.0.0.x with nonzero x, the server must read in the domain name that the client sends in the packet. The server should resolve the domain name and make connection to the destination host if it can.
FreeLAN, open-source, free, multi-platform IPv4, IPv6 and peer-to-peer VPN software over UDP/IP. n2n, an open source Layer 2 over Layer 3 VPN application which uses a peer-to-peer architecture for network membership and routing; Tinc, Ethernet/IPv4/IPv6 over TCP/UDP; encrypted, compressed
As there are only two endpoints on a tunnel, the tunnel is a point-to-point connection and PPP is a natural choice as a data link layer protocol between the virtual network interfaces. PPP can assign IP addresses to these virtual interfaces, and these IP addresses can be used, for example, to route between the networks on both sides of the tunnel.
Settings may be in a different location in each email client, though the AOL server and port settings will always be the same. For additional questions specific to the email client, check the manufacturer’s website. Manufacturers cannot answer questions about your AOL Mail settings, or your AOL username or password.
The Hypertext Transfer Protocol uses the keyword "Keep-Alive" in the "Connection" header to signal that the connection should be kept open for further messages (this is the default in HTTP 1.1, but in HTTP 1.0 the default was to use a new connection for each request/reply pair). [8]