When.com Web Search

  1. Ads

    related to: drill speed for drilling rock

Search results

  1. Results From The WOW.Com Content Network
  2. Rate of penetration - Wikipedia

    en.wikipedia.org/wiki/Rate_of_penetration

    In the drilling industry, the rate of penetration (ROP), also known as penetration rate or drill rate, is the speed at which a drill bit breaks the rock under it to deepen the borehole. It is normally measured in feet per minute or meters per hour, but sometimes it is expressed in minutes per foot.

  3. Underground rocket - Wikipedia

    en.wikipedia.org/wiki/Underground_rocket

    An underground rocket or rocket drill is a device for rapidly drilling holes through soil and rock of varying composition at rates up to 1 metre per second [1] [2] by utilising supersonic jets of hot gases. It was developed by Russian engineer Mikhail Tsiferov in 1948. [3]

  4. Drilling rig - Wikipedia

    en.wikipedia.org/wiki/Drilling_rig

    Drilling rigs used for rock blasting for surface mines vary in size dependent on the size of the hole desired, and is typically classified into smaller pre-split and larger production holes. Underground mining (hard rock) uses a variety of drill rigs dependent on the desired purpose, such as production, bolting, cabling, and tunnelling.

  5. Drilling - Wikipedia

    en.wikipedia.org/wiki/Drilling

    Peck drilling involves plunging the drill part way through the workpiece, no more than five times the diameter of the drill, and then retracting it to the surface. This is repeated until the hole is finished. A modified form of this process, called high speed peck drilling or chip breaking, only retracts the drill slightly. This process is ...

  6. Drifter drill - Wikipedia

    en.wikipedia.org/wiki/Drifter_drill

    Rock drill mounted on a tripod. The large objects on the legs are weights to anchor it down into position. In reciprocating power drills, the drilling cylinder is mounted on a feed-screw, such that as the hole is drilled and the drilling point recedes from the rock face, the drill-bit continues to move into it, while the anchor point (on the tripod or column) remains in place. [11]

  7. Drilling and blasting - Wikipedia

    en.wikipedia.org/wiki/Drilling_and_blasting

    As the name suggests, drilling and blasting works as follows: A blast pattern is created; A number of holes are drilled into the rock, which are then partially filled with explosives. Stemming, inert material, is packed into the holes to direct the explosive force into the surrounding rock. [6] Detonating the explosive causes the rock to collapse.