Search results
Results From The WOW.Com Content Network
Wing twist is an aerodynamic feature added to aircraft wings to adjust lift distribution along the wing.. Often, the purpose of lift redistribution is to ensure that the wing tip is the last part of the wing surface to stall, for example when executing a roll or steep climb; it involves twisting the wingtip a small amount downwards in relation to the rest of the wing.
Washout is commonly achieved by designing the wing with a slight twist, reducing the angle of incidence from root to tip, and therefore causing a lower angle of attack at the tips than at the roots. This feature is sometimes referred to as geometrical washout, to distinguish it from aerodynamic washout.
Aircraft wing showing the KFm2 Step Aircraft wing showing the KFm3 Step. The Kline–Fogleman airfoil or KF airfoil is a simple airfoil design with single or multiple steps along the length of the wing. The purpose of the step, it is claimed, is to allow some of the displaced air to fall into a pocket behind the step and become part of the ...
Angle of incidence of an airplane wing on an airplane. On fixed-wing aircraft, the angle of incidence (sometimes referred to as the mounting angle [1] or setting angle) is the angle between the chord line of the wing where the wing is mounted to the fuselage, and a reference axis along the fuselage (often the direction of minimum drag, or where applicable, the longitudinal axis).
Divergence is a phenomenon in which the elastic twist of the wing suddenly becomes theoretically infinite, typically causing the wing to fail. Control reversal is a phenomenon occurring only in wings with ailerons or other control surfaces, in which these control surfaces reverse their usual functionality (e.g., the rolling direction associated ...
The rudder is a fundamental control surface which is typically controlled by pedals rather than at the stick. It is the primary means of controlling yaw—the rotation of an airplane about its vertical axis. The rudder may also be called upon to counter-act the adverse yaw produced by the roll-control surfaces.
A fixed-wing aircraft may have more than one wing plane, stacked one above another: Biplane: two wing planes of similar size, stacked one above the other.The biplane is inherently lighter and stronger than a monoplane and was the most common configuration until the 1930s.
A wing of infinite span and uniform airfoil segment (or a 2D wing) would experience no induced drag. [11] The drag characteristics of a wing with infinite span can be simulated using an airfoil segment the width of a wind tunnel. [12] An increase in wingspan or a solution with a similar effect is one way to reduce induced drag.