Ads
related to: rcf art 945 12 pin adapter to 4bhphotovideo.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
Pin A is for activation of so-called Blackout Mode. It turns off all the lights except convoy lighting if it is active. The lighting inside the vehicle shall also be extinguished if it is not specifically shaded. Pin C is for Convoy Lamps, which is the special convoy lighting, corresponding to the tail lights, to be used while driving in the dark.
12 Volt 7-pin trailer connector ISO 7638-2 for ABS and EBS (Towing vehicle side) Physical design according to standard ISO 7638-2. [4] [6] [7] This connector is intended to be used for 12V ABS and EBS on heavy duty trailers. Identified by key tab on outer ring between pin 3 and 4. #
Multicon [1] Feder and Multicon WeSt (Welt Standard) connectors are precursors to ISO 11446 in a design that is intended to be compatible with ISO 1724.This means that if a towing vehicle has an outlet of this type it should be able to connect a trailer with a standard 7-pin or 5-pin connector according to ISO 1724, provided that the trailer coupling follows the standard and that the trailer ...
In some cases – as in the flat 4-pin or 5-pin connector – it is fairly obvious which color that is connected to which pin. In case you have a vehicle that separates the left and right side position lights into 58L and 58R – like many German cars – it is advisable to choose 58L to feed the taillights.
In the broadcast, film, and television industries, the 4-pin XLR connector is the standard for 12 V power. The connectors are wired pin 1 negative, pin 4 positive. Often pins 1 and 2 will be negative, 3 and 4 positive for a higher current rating. Female connectors are used as supply and male connectors are used on loads.
When used as intended, the ground pin of the 3-wire receptacle is to be connected to a grounded cover screw, or to an external ground. In 1969, Underwriters Laboratories mandated three-prong plugs on major appliances for safety. [7] At that time, only half of the receptacles in US homes were three-prong. [7]
14-pin connector: printer port used on MSX home computers and on various other Japanese computers such as the NEC PC-6000, PC-8800 and PC-9800 series [2] 20-pin connector: VESA Digital Flat Panel digital video interface; 24-pin connector: IEEE 488 (GPIB, HP-IB) interface [3] 36-pin connector: IEEE 1284 parallel interface
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.