Ad
related to: 383 chrysler engine specs for sale ford
Search results
Results From The WOW.Com Content Network
The Ford MEL is a big-block 90° V8 engine family produced in various configurations by the Ford Motor Company between 1958 and 1967 in displacements from 383–462 cubic inches (6.3–7.6 L), and used in Ford, Edsel, Mercury, and Lincoln vehicles.
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5] It was one of the last carbureted car/truck engines built in North America. [6] Chrysler never used this engine in any other vehicle.
It also saw the introduction of the 340 4-BBL option and a detuned 383 "Road Runner" engine with 8.7:1 compression and power dropping to 300 hp (224 kW). In return, Road Runners with the 340 and 383 engines received a standard insurance rating without the costly premiums normally tacked onto muscle cars. The 383 would now run on regular gas.
Jensen Motors used Chrysler V8 engines for the Interceptor, starting with the 6,276 cc (383 c.i.) with optional manual (Mark I, 22 built) or TorqueFlite automatic transmissions driving the rear wheels through a limited slip differential in a conventional Salisbury rear axle. In 1970, the 383 c.i. produced 335 hp SAE gross, or 270 hp SAE net.
The Polyspheric engines were V8 engines produced by Chrysler from 1955 to 1958 as lower-cost alternatives to its Hemi engines. [1] These engines were based on the Hemi engines, using the same blocks and crankshaft parts, but completely different cylinder heads, pushrods, exhaust manifolds and pistons.
Chrysler used a 14 mm (0.55 in) spark plug, rather than the typical 18 mm (0.71 in), in an effort to fit it as centrally as possible in the combustion chamber. [ 1 ] The intake and exhaust valves were the same size as the 426's, [ 6 ] the 2.25 in (57 mm) intake canted at 15° from the bore centerline, the 1.94 in (49 mm) exhaust at 6°. [ 6 ]
The Ford single overhead cam (SOHC) 427 V8 engine, familiarly known as the "Cammer", [25] was released in 1964 in an effort to maintain NASCAR dominance by seeking to counter the enormously large block Chrysler 426 Hemi "elephant" engine. The Ford 427 block was closer dimensionally to the smaller 392 cu. in. first generation Chrysler FirePower ...