Ad
related to: exhaust back pressure tester auto zone system manual
Search results
Results From The WOW.Com Content Network
Two similar pipings with same pressure distance and head. The second pipe contains some obstructions for flow resulting in less discharge. A common example of backpressure is that caused by the exhaust system (consisting of the exhaust manifold, catalytic converter, muffler and connecting pipes) of an automotive four-stroke engine, which has a negative effect on engine efficiency, resulting in ...
Adding exhaust gas therefore reduces pressure and temperature during the isentropic compression in the cylinder, thereby lowering the adiabatic flame temperature. In a typical automotive spark-ignited (SI) engine, 5% to 15% of the exhaust gas is routed back to the intake as EGR. The maximum quantity is limited by the need of the mixture to ...
A reduced pressure zone device (RPZD, RPZ, or RPZ valve) is a type of backflow prevention device used to protect water supplies from contamination. RPZDs may also be known as reduced pressure principle (RP), reduced pressure principle backflow prevention devices, [1] [2] reduced pressure zone assemblies (RPZA), [3] or reduced pressure principle ...
An exhaust brake is a valve which essentially creates a back-pressure in the exhaust system, which applies enough force onto the engine's pistons to slow the engine. In most cases, an exhaust brake is so effective that it can slow a heavily-loaded vehicle on a downgrade without ever applying the vehicle’s service brakes.
The Turbo-back (or turbo back) is part of the exhaust system from the outlet of a turbocharger to the final vent to open air. Turbo-back systems are generally produced as aftermarket performance systems for cars with turbochargers. Some turbo-back (and header-back) systems replace stock catalytic converters, while others have less flow restriction.
H, pressure drop across test piece in pascals measured by the test pressure manometer d , density of air in kilograms per cubic meter ( 1.20 kilograms per cubic meter at standard conditions ) This represents the highest speed of the air in the flow path of a normally shaped port, at or near the section of minimum area ( through the valve seat ...
Compression tests should normally be done with all spark plugs removed to maximize cranking speed. Cranking compression is a dynamic test of the actual low-speed pumping action, where peak cylinder pressure is measured and stored. A compression tester. Leak-down testing is a static test. Leak-down tests cylinder leakage paths.
The test involves filling the vessel or pipe system with a liquid, usually water, which may be dyed to aid in visual leak detection, and pressurization of the vessel to the specified test pressure. Pressure tightness can be tested by shutting off the supply valve and observing whether there is a pressure loss.