Search results
Results From The WOW.Com Content Network
Multicon [1] Feder and Multicon WeSt (Welt Standard) connectors are precursors to ISO 11446 in a design that is intended to be compatible with ISO 1724.This means that if a towing vehicle has an outlet of this type it should be able to connect a trailer with a standard 7-pin or 5-pin connector according to ISO 1724, provided that the trailer coupling follows the standard and that the trailer ...
12 Volt 7-pin trailer connector ISO 7638-2 for ABS and EBS (Towing vehicle side) Physical design according to standard ISO 7638-2. [4] [6] [7] This connector is intended to be used for 12V ABS and EBS on heavy duty trailers. Identified by key tab on outer ring between pin 3 and 4. #
Pin A is for activation of so-called Blackout Mode. It turns off all the lights except convoy lighting if it is active. The lighting inside the vehicle shall also be extinguished if it is not specifically shaded. Pin C is for Convoy Lamps, which is the special convoy lighting, corresponding to the tail lights, to be used while driving in the dark.
In some cases – as in the flat 4-pin or 5-pin connector – it is fairly obvious which color that is connected to which pin. In case you have a vehicle that separates the left and right side position lights into 58L and 58R – like many German cars – it is advisable to choose 58L to feed the taillights.
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
For Wide SCSI-2, the most common connector was the larger 68-pin sibling of the HD50, known as the HD68, MiniD68, HPDB68, and sometimes as "SCSI-3". This is about 1 7/8” (47mm) wide. [ 3 ] IBM used the HDCN68 on some RS-6000 systems, and it seems likely that a few other manufacturers used other alternatives.
For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...
A thin quad flat pack (TQFP) provides the same benefits as the metric QFP, but is thinner. Regular QFP are 2.0 to 3.8 mm thick depending on size. TQFP packages range from 32 pins with a 0.8 mm lead pitch, in a package 5 mm by 5 mm by 1 mm thick, to 256 pins, 28 mm square, 1.4 mm thick and a lead pitch of 0.4 mm. [2]