When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Power factor - Wikipedia

    en.wikipedia.org/wiki/Power_factor

    Power factor correction brings the power factor of an AC power circuit closer to 1 by supplying or absorbing reactive power, adding capacitors or inductors that act to cancel the inductive or capacitive effects of the load, respectively. In the case of offsetting the inductive effect of motor loads, capacitors can be locally connected.

  3. Valley-fill circuit - Wikipedia

    en.wikipedia.org/wiki/Valley-fill_circuit

    A valley-fill circuit is a type of passive power-factor correction (PFC) circuit. For purposes of illustration, a basic full-wave diode-bridge rectifier is shown in the first stage, which converts the AC input voltage to a DC voltage.

  4. Active rectification - Wikipedia

    en.wikipedia.org/wiki/Active_rectification

    Using active rectification to implement AC/DC conversion allows a design to undergo further improvements (with more complexity) to achieve an active power factor correction, which forces the current waveform of the AC source to follow the voltage waveform, eliminating reactive currents and allowing the total system to achieve greater efficiency.

  5. Static synchronous compensator - Wikipedia

    en.wikipedia.org/wiki/Static_synchronous_compensator

    The STATCOM also provides better reactive power support at low AC voltages than an SVC, since the reactive power from a STATCOM decreases linearly with the AC voltage (the current can be maintained at the rated value even down to low AC voltage), as opposed to power being a function of a square of voltage for SVC. [38]

  6. Vienna rectifier - Wikipedia

    en.wikipedia.org/wiki/Vienna_rectifier

    Turning off the switch causes the voltage across the inductor to reverse and the current to flow through the freewheeling diodes Da+ and Da-, decreasing linearly. By controlling the switch on-time, the topology is able to control the current in phase with the mains voltage, presenting a resistive load behavior (Power-factor correction capability).

  7. Power factor correction - Wikipedia

    en.wikipedia.org/?title=Power_factor_correction&...

    Retrieved from "https://en.wikipedia.org/w/index.php?title=Power_factor_correction&oldid=1229765582"

  8. Form factor (electronics) - Wikipedia

    en.wikipedia.org/wiki/Form_factor_(electronics)

    In electronics and electrical engineering, the form factor of an alternating current waveform (signal) is the ratio of the RMS (root mean square) value to the average value (mathematical mean of absolute values of all points on the waveform). [1] It identifies the ratio of the direct current of equal power relative to the given alternating ...

  9. Power-factor correction - Wikipedia

    en.wikipedia.org/?title=Power-factor_correction&...

    This page was last edited on 15 September 2008, at 22:25 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.